CVR700 OM 12/17/04 4:23 PM Page 18
SOURCE line to adjust it). Scroll downNOTE: 6.1 and 7.1 digital modes are
to the VIDEO INPUT line andavailable only when the appropriate digi-
select it to configure the CVR700 to usetal bitstream is present.
the video input you connected your( Input Select Button: After you have
device to.selected the desired input source, press
% Headphones Jack: This jack maythis button repeatedly to scroll through
be used to listen to the CVR700's outputthe analog, optical digital and coaxial
through a pair of headphones. Be certaindigital audio inputs available for that
that the headphones have a standardsource.
1/4" stereo phone plug, or that you useî Volume Control: Turn this knob
an adapter, as needed, to convert theclockwise to increase the volume, coun-
plug on your headphones to the 1/4" jackterclockwise to decrease the volume. If
used on the CVR700. When the head-the CVR700 is muted, adjusting the vol-
phone jack is in use, the main roomume control will automatically release
speakers will automatically be turned offthe unit from the silenced condition.
and the unit will output a standard stereoi Information Display: This display
signal. For more information on head-delivers messages and status information
phone listening, see page 60.to help you operate the CVR700. See
^ Front-Panel Door: The door may page 19 for a complete explanation of
be closed to hide the front-panel jacksthe display.
when they are not in use for a smoother
appearance. To open the door, gently� Remote Sensor Window: The sen-
push on the bottom of the door in thesor behind this window receives infrared
center to swing it down towards you, orsignals from the remote control that are
gently pull on the upper right corner. Pushintended to control the non-video func-
upward on it to close.tions of the CVR700 only. Aim the remote
at this area and do not block or cover
& Source Selector: Rotate this knobit unless an external remote sensor is
to scroll through the available inputinstalled. Note that unless the CVR700
sources. Turn the knob slowly and gently,is not being used with the CVPD50, it is
and you will feel a soft click as eachbest to aim the remote at the LED light
source is engaged. You may also hear aon the front of the CVPD50 plasma dis-
click as the CVR700Os electrical circuitsplay, as the IR receiver located there can
engage the source. This is normal, andaccept remote control signals intended
assures you that you have correctlyfor both the plasma display and the
selected the source. The name of theCVR700.
source will be displayed in the Upper
Display Line H, and in a Status Banner
on screen, together with the sourceOs
for external sources
video format.
* Surround Mode Selector: Press
this button repeatedly to scroll through
the available surround modes. The modes
available will depend on the number of
speakers in the system and whether the
input is analog or digital. See page 60 for
more information on surround modes.
18 |
ACEC
