G SERIES LOUDSPEAKERS
be sent to your main speakers orreproduce. It allows a seamless
satellites. Your G Sub10 subwoofertransition from subwoofer to satellite
can use the signal from yourspeakers. When using small satellite
receiver/TV/source ampliŢer tospeakers (without much bass), you
produce the low bass while passingwould want the crossover frequency
the unaltered signal source to themore toward the upper end (200 Hz)
external speakers. to Ţll in the sound your satellites can't
Speaker Level Output (to externalreproduce. When using larger main
speakers, a setting more toward the
speakers) � Hook up the external
speakers using two-conductorlow (50 Hz) end gives a smoother
transition from your subwoofer to your
insulated wire using the same
main speakers. Experiment until you
procedure as described in OSpeakerŢnd a setting that meets your
Level Input� section. The red (+)
satisfaction.
terminal of the subwoofer should be
connected to the red (+) terminal of
MULTICOLOR LED
the external speaker, and the black
(�) to black. Connecting the externalINDICATOR OPERATION
speakers in this manner ensures thatThe LED on the rear amp plate
they will be in phase; that is, worksigniŢes the following operation states
together rather than in opposition.of the G Sub10 subwoofer:
Connecting the speakers out of phaseRED � When your subwoofer isn't
will not damage them, but will result receiving a music or source signal
in less bass and poor imaging and the power switch is turned on, the
(see Figure. 3).LED indicator turns RED telling you
NOTE: There is no signiŢcant changethat the unit is plugged in and ready
for operation. At this time, the
in impedance loading to your
receiver/TV/source ampliŢer ampliŢer is in a "Standby" mode,
effectively turned off and waiting for a
when hooking up through the
signal from the source ampliŢer.
G Sub10 subwoofer.GREEN � When your subwoofer,
picks up a source signal, it turns on
LEVELinstantly and begins to play. The LED
NOTE: When Ţrst setting up yourturns GREEN. After about 6 to 8
subwoofer, set the Level controlminutes of non-use (no signal being
counterclockwise to "Min" (minimum)received), your subwoofer goes into
before turning power switch ON.the auto shut-off mode. The LED
turns RED to signify this "Standby"
Turn power switch to OOn,� and use
the "Level"knob to add thecondition.
appropriate amount of bass to yourNOTE: When the ampliŢer is in the
main speaker output. Increase the?Standby? mode it is effectively turned
subwoofer level by turning the leveloff. The Red LED tells you that the
subwoofer is plugged into the AC wall
knob clockwise until you Ţnd a setting
that is pleasing to you.power with its power switch turned on,
but the ampliŢer circuitry is not
engaged. You do not have to reach to
CROSSOVERthe back panel and turn the power
FREQUENCYswitch off after every use. Your
Use the "Crossover Freq"knob G Sub10 subwoofer turns itself off
to adjust the upper end of the sub-internally. For extended periods of
woofer's frequency response. Thenon-use (i.e., vacations, etc.), you
crossover control determines themay wish to actually turn the
highest frequency your subwoofer willsubwoofer off using the power switch.
5 |