Troubleshooting
If a problem occurs when you are using the TV, check the below
Y Cannot operate the Y The batteries may be exhausted. Replace with
troubleshooting guide before calling for repair.
remote controlnew batteries (see page 7).
Y Ensure that you are operating the remote less
Y No picture,Y Deactivate the BLUE BACK function if it is turnedthan seven meters from the front of your TV.
no soundon.Y Cannot operate the Y Press TV/VIDEO button to return to TV mode and
Y Snowy pictureY Check the aerial cable and its connection with themenustry operating the menus.
TV.Y Cannot operate the Y Deactivate the CHILD LOCK function if it is turned
Y Stripes appear on Y Interference occurs caused by other devices suchfront control buttons on (see page 15).
the pictureas an amplifier, personal computer, or a hair drier.Y TV is turned offY This may due to the AUTO SHUT OFF function is
Move such devices away from your TV.suddenlyactivated. Press the POWER button to turn on the
Y Double-picturesY Interference occurs caused by signal reflectingTV.
(ghosting) occurfrom mountains or building. Try to adjust theY Color patchesY This may due to the magnetized device such as a
aerialOs direction or use a better directionalityappear at the corner speaker near to your TV. Keep the device apart
antenna.of the screenfrom your TV. Alternately, you can also use the
Y Poor pictureY Choose the appropriate colour system. Refer tomagnetic-shielded speaker.
OCOLOR SYSTEM� on page 9.Y Picture is tiltedY This may due to the earth magnetism. Refer to
Y Adjust the COLOR or BRIGHT setting. Refer toOPICTURE TILT� on page 11 to correct the tilt.
OAdjusting the picture - USER� on page 10.Y Image takes a short Y Image required time to stabilize before display.
Y White and bright still Y Inevitable phenomenon due to the nature of theperiod to beThis is not a malfunction.
image look as if itpicture tube. This is not a malfunction.displayed
were colored
Y TV may emittedY This is due to a sudden change in temperature
Y Top of the imageY This is due to the condition of the video signalcrackling soundand it is not a malfunction. If the crackling sound
from softwarewhereby the image was not recorded properly.is too frequent, request your service technician for
products or videoThis is not a malfunction.inspection.
tape is distortedY Feel a slight electric Y This is due to the static electricity of the picture
Y Poor soundY Adjust the sound frequency properly. Refer toshock whentube and it will not harm the human body. This is
OEQUALIZER� on page 13.touching the TVnot a malfunction.
Y Stereo or bilingual Y TV channel reception is poor. Change the stereo/screen
sound is unclearbilingual mode to mono sound (see page 13).
19
GGT0055-001A-H(11-20)197/27/04, 2:50 PM |
ACEC
