CONNECTIONCONNECTION
Connecting with SERIAL REMOTE terminalsConnecting the AC adapter
The following describes examples of SERIAL REMOTE terminal connection.Connect the supplied AC adapter to BR-HD50.
To use the SERIAL REMOTE terminals, set REMOTE SEL SER of the REMOTE [1/2] Menu screen
to ?ON? or ?LOC+REM.? (XPage 70)1. Clamp
Screw
? Operate BR-HD50 with the wired remote controller3. Clamp
Connect the wired remote controller to the
SERIAL REMOTE terminal.
Supplied AC adapter
DC IN terminal
4.
Supplied power cord
SERIAL DC cord2.
REMOTE
Wired remote
controllerSupplied ferrite core5.
? Start/stop recording with an external switch, e.g., a foot switch.
? Always attach the supplied ferrite core
Connect an external switch, e.g., a foot switch,OPERATE indicator
to the SERIAL REMOTE terminal.to the DC cord. (XPage 29)
The format of the input signals can be selected1.Remove one screw on the back panel of the
with FOOT SW in the REMOTE [2/2] Menuunit, and remove the DC cord clamp.OPERATE
button
screen. (XPage 71)
2.Connect the DC cord of the AC adapter to
the DC IN terminal of BR-HD50.
SERIAL 3.To prevent accidental disconnection of the
REMOTEDC cord, insert the DC cord into the clamp,
orient the clamp as shown in the figure
above, and secure the clamp to the unit.
Foot MemoUse the screw removed in step 1 above to
switch
z Even in the OPERATE OFF mode, a smallsecure the clamp to the unit.
amount of electricity will still flow into the unit.4.Connect the supplied power cord to the AC
z When the unit is in the OPERATE OFF mode,IN terminal of the AC adapter.
no operation can be performed except that of
5.Connect the power cord to the power out-
the OPERATE buttons and cassette loading/
let.
ejecting.
?BR-HD50 is turned on and the OPERATE
indicator lights up in red.
(OPERATE OFF mode)
? If DC IN MODE of the SYSTEM [2/2] Menu
screen is set to ?OPE ON?, the OPERATE
indicator will light up in green.
(OPERATE ON mode)
Note
z Supply power to BR-HD50 using the supplied AC adapter. Do not
use other power sources.
z Do not unplug the DC cord and/or the power cord during recording
or playback.LOW VOLTAGE
z If the supply voltage is low, an alarm display of ?LOW VOLTAGE?
is shown.
Alarm message
E-30E-31 |
ACEC
