Continued
English
Using Recording Timer
4Set the on-time you want the
unit to turn on at.
With Recording Timer, you can make a tape of a radio
1) Turn4 / c to set the hour,broadcast automatically. You can set the timer whether the
then press SET/DISPLAY.
system is on or off.
2) Turn4 / c to set the minute,
then press SET/DISPLAY.
OOFF TIME� appears for 2How Recording Timer actually works
The unit automatically turns on, tunes into the specified
seconds, then the unit enters off-station, sets the volume level to OVOL MIN,� and starts
time setting mode.
recording when the on-time comes (the indicator flashes
just before the on-time, and continues flashing while the
5Set the off-time you want the
unit to turn off (on standby) at.timer is operating). Then, when the off-time comes (OOFF�
appears just before the off-time), the unit automatically turns
1) Turn4 / c to set the hour, then pressoff (on standby).
SET/DISPLAY.
The timer setting remains in memory until you change it.
2) Turn4 / c to set the minute, then pressY There is a time limit in doing the following steps. If the
SET/DISPLAY.
The unit enters preset station selecting mode.setting is canceled before you finish, start from step 1
again.
Y To correct a mis-entry while setting the timer, press
6Select the preset station.
CANCEL/DEMO.
1) Turn4 / c to select the band (OTUNER FM� or
OTUNER AM�), then press SET/DISPLAY.
On the unit ONLY:
2) Turn4 / c to select a preset channel number,
1Put a recordable cassette into deck B.then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing
2Press CLOCK/TIMER repeatedlyand remains lit. The settings you have done are shown
on the display in sequence.until OREC� appears on the
display.
The REC (Recording Timer) indicator also7Press STANDBY/ON toSTANDBY/ON
starts flashing on the display.turn off the unit (on standby)STANDB Y
if necessary.
Y If you want to listen to another source while recording
Press REC START/STOP or 7 to stop recording. Without
Y Each time you press the button, the timer setting modesstopping it, you cannot change the source.
Y Even if you unplug the AC power cord or if a power failurechange as follows:
occurs
DAILYON TIMERECOnce you set the timer, the timer setting may remain stored in
memory in a few days. In this case, check whether the timer
CanceledClockON TIMEsetting still remains or not.
setting
(See page 9.)
3Press CLOCK/TIMER again.
OON TIME� appears for 2 seconds, then the
unit enters on-time setting mode.
� 24 �
EN18-30.CA-MXGT90&80&70[UJ,UW]f243/22/01, 10:09 AM |
ACEC
