Common Operations
English
Turning On or Off the PowerTo check the clock time
Press and hold SET/DISPLAY while playing any source.
To turn on the unit, pressY Each time you press and hold the button, the sourceSTANDBY/ON
STANDBY/ON so that theSTANDBYindication and the clock time alternate on the display.
STANDBY lamp goes off.
To adjust the clock again
If you have adjusted the clock before, you need to pressSTANDBY/ON
To turn off the unit (on standbpress y), CLOCK/TIMER repeatedly until the clock setting mode is
STANDBY/ON again so that theSTANDB Yselected.
STANDBY lamp lights up.Y Each time you press the button, the clock/timer setting
modes change as follows:
DAILYON TIMEREC
Y A little power is always consumed even while the unit is onCanceledClockON TIME
setting
standby.(The hour digits start flashing.)
To switch off the power supply completelyunplug the , ACWhen you unplug the AC power cord or if a power
power cord from the AC outlet.failure occurs
The clock loses the setting and is reset to O0:00.� You need to set the
When you unplug the AC power cord or if a poclock awergain.
failure occurs
The clock is reset to O0:00� right away, while the tuner prSetting the AM Tesetuner Interval Spacing
stations (see page 12) will be erased in a few days.
Some countries space AM stations 9 kHz apart, and some
Setting the Clockcountries use 10 kHz spacing.
Before operating the unit any further, first set the cOn the unit ONLlock bY:uilt
in this unit. You can set the clock whether the unit is on or
off.You can only change the AM tuner interval
spacing while tuning into an AM station.
(See page 12.)
On the unit ONLY:
Press STANDBY/ON while holding
1Press CLOCK/TIMER.down 7.STANDBY/ON
The hour digits start flashing on the display.STANDBY
Y Each time you press these buttons, the
AM tuner interval spacing alternates
between 9 kHz and 10 kHz.
2Turn 4 / c to adjustSelecting the Sources
the hour, then press
SET/DISPLAY.To listen to the FM/AM broadcasts, press FM/AM.
The minute digits start flashing on the(See page 12.)
display.To play back CDs,press CD 3´8. (See pages 13 � 16.)
To play back tapress Tpes, APE 2 3. (See page 17.)
To select the external equipment as the sourpress AUX. ce,
Y If you want to correct the hour
after pressing SET/DISPLAY,
press CANCEL/DEMO.
The hour digits start flashing again.
When you press the play button for a particular source
(FM/AM, CD 3/8, TAPE 2 3, and AUX), the unit turns on
3Turn 4 / c to adjust the minute, then(and the unit starts playing the source if it is ready
press SET/DISPLAY.N COMPU PLAY CONTROL).
About the audio level indicator
All the audio level indicators light up when no signals come in.
� 9 �
EN01-12.CA-MXGT90&80&70[UJ,UW]f93/21/01, 6:26 PM |
ACEC
