Listening to FM and AM Broadcasts
Tuning in a Station
2Press SET.
SET
On the unit ONLY:
1Press FM/AM.BASSST
SOUND MODEREC
The unit automatically turns on and tunes in
FM /AM � PRESET +
the previously tuned station (either FM or3Press PRESET � / + to select a
AM). (For MX-J300 only, the Poweredpreset number.
Rolling Panel automatically opens.)
Y Each time you press the button, the band alternates
between FM and AM.
BASSST
SOUND MODEREC
� TUNING +
2Press and hold TUNING � / + for
4Press SET again.
more than 1 second.SET
The unit starts searching for stations and
stops when a station of sufficient signalST
BASS
SOUND MODEREC
strength is tuned in.
If a program is broadcast in stereo, the ST (stereo)
The tuned station in step 1 is stored in the preset number
indicator lights up.
selected in step 3.
Y Storing a new station on a used number erases the
To stop during sear press ching,TUNING � / +.
previously stored one.
When you unplug the AC power cord or if a power
When you press TUNING � / + briefly and repeatedly
failure occurs
The frequency changes step by step.
The preset stations will be erased in a few days. If this happens,
preset the stations again.
To change the FM reception mode
FM MODE
When an FM stereo broadcast is hard to receive or
Tuning in a Preset Station
noisy, press FM MODE on the remote control so
that the MONO indicator lights up on the display.
1Press FM/AM.
Reception improves.
The unit automatically turns on and tunes inFM /AM
To restore the stereo effect, press FM MODE again so that
the previously tuned station (either FM or
the MONO indicator goes off.
AM.) (For MX-J300 only, the Powered
In this stereo mode, you can hear stereo sounds when a
Rolling Panel automatically opens.)
program is broadcast in stereo.
Y Each time you press the button, the band alternates
between FM and AM.
Presetting Stations� PRESET +
2Select a preset number.
On the unit:
You can preset 30 FM and 15 AM stations.
Press PRESET � / +.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner presetOn the remote control:
function before shipment. This is not a malfunction. Press the number bYou canuttons.
123
preset the stations you want into memory by following theFor preset number 5, press 5.
presetting method.For preset number 15, press +10
456
Y There is a time limit in doing the following steps. If thethen 5.
setting is canceled before you finish, start from step 1For preset number 20, press +10,
789
again.then 10.
For preset number 25, press +10,
10+10
1Tune in the station you want to preset.+10, then 5.
Y See OTuning in a Station� above.
MHz
BASSST
SOUND MODEREC
� 14 �
MX-J300/200[J] 01-14 EN1400.4.10, 11:10 AM |
ACEC
