Continued
Getting Started
English
UnpackingConnecting Antennas
After unpacking, check to be sure that you have all theFM antenna
following items.
The number in the parentheses indicates the quantity of the
pieces supplied.
ANTENNA
Y AM loop antenna (1)GND FM antenna (supplied)LOOP
Y FM antenna (1)AM EXT
Y Remote control (1)
Y Batteries (2)
FM 75
COAXIAL
If any is missing, consult your dealer immediately.
Putting the Batteries into the Remote Control
Insert the batteries N R6P(SUM-3)/AA(15F) N into the1Attach the FM antenna to the FM 75 W
remote control, by matching the polarity (+ and �) on theCOAXIAL terminal.
batteries with the + and � markings on the battery
compartment.2Extend the FM antenna.
When the remote control can no longer operate the unit,
replace both batteries at the same time.3Fasten it up in the position which gives you
the best reception.
1
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
R6P(SUM-3)/AA(15F)2antenna.
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
3Outdoor FM antenna
(not supplied)
Y DO NOT use an old battery together with a new one.
ANTENNA
Y DO NOT use different types of batteries together.
Y DO NOT expose batteries to heat or flame.GND
LOOP
Y DO NOT leave the batteries in the battery
AM EXT
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, it will be damaged from battery leakage.FM 75
COAXIAL
A 75W antenna with coaxial type connector (DIN 45325)
should be used.
� 6 �
EN01-13.CA-MXJ30/35R[EV]/f699.4.19, 7:18 PM |
ACEC
