Common Operations
English
Setting the ClockTurning On the Power and Selecting the
Sources
Before operating the unit any further, first set the clock built
in this unit.When you press the play button for a particular source (FM/
PANELAM, CD 6, AUX, and TAPE 2 3), the unit turns on, and
OPEN / CLOSE
1Press PANEL OPEN/CLOSE.the Powered Rolling Panel opens automatically (and the unit
The unit is turned on and the Powered Rollingstarts playing the source if it is ready N COMPU PLAY
Panel opens automatically.CONTROL).
TIMERTo listen to the FM/AM (MW/LW) broadcasts, press FM/
2Press TIMER/CLOCK./CLOCK
AM. (See pages 12 � 14.)
To play back CDs, press CD 6. (See pages 15 � 17.)
To play back taprpes,ess T APE 2 3. (See page 18.)
To select the external equipment as the sour press AUX.ce,
The hour digits start flashing on the display.
PRESETFM AM/TAPE
CD
AUX
3Press 4 or c to adjust the
hour, then press SET.
STANDBY
To turn on the unit without plapress ying,
SEA CONTROL
SETso that the STANDBY lamp goes off.
Y If you want to correct the hour after pressing
SET, press CANCEL. The hour digits start
flashing again.
The Powered Rolling Panel opens automatically.
PRESET
4Press 4 or c to adjust the
STANDBY
minute, then press SET.To turn off the unit (on standby), press
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.
A little power is always consumed even while the
SEA CONTROL
SETunit is on standby.
To switch off the power supply completelyunplug the , AC
To check the clock timepower cord from the AC outlet.
DISPLAY
Press DISPLAY while playing any source.
Y Each time you press the button, the source
indication and the clock time alternate on theWhen you unplug the AC power cord or if a power
failure occurs
display.
The clock is reset to O0:00� right away, while the tuner preset
stations (see page 12) will be erased in a few days.
To adjust the clock again
If you have adjusted the clock before, you need to press
TIMER/CLOCK repeatedly until the clock setting mode is
selected.
Y Each time you press the button, the timer/clock setting
modes change as follows:
DAILYON TIMEREC
CanceledClockON TIME
setting
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to O0:00.� You need to set the
clock again.
� 9 �
EN01-14.MXJ55/530R[E]/2999.2.19, 5:19 PM |