Troubleshooting
English
If you are having problems with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
SymptomCauseAction
No sound is heard.Connections are incorrect or loose.Check all connections and make
corrections. (See pages 6 to 8.)
Hard to listen to broadcasts because ofY Antennas are disconnected. Y Reconnect the antennas correctly and
noise.securely.
Y The AM loop antenna is too close toY Change the position and direction of
the unit.the AM loop antenna.
Y The FM antenna is not properlyY Extend the FM antenna in the best
extended and positioned.position.
The disc sound is discontinuous.The disc is scratched or dirtyClean or replace the disc. (See page 29.).
The disc tray does not open or close.Y The AC power cord is not plugged in.Y Plug in the AC power cord.
Y Trays are locked.Y Unlock the trays. (See page 15.)
The disc does not play.The disc is placed upside down.Place the disc with the label side up.
The cassette holders cannot be opened.Power supply from the AC power cordTurn on the unit.
has been cut off while the tape was
running.
Impossible to record.Small tabs on the back of the cassetteCover the holes with adhesive tape.
are removed.
Stereo effect is lost.Vocal Masking is activated. Cancel the Vocal Masking (See page 24.)
Operations are disabled.The built-in microprocessor may beUnplug the AC power cord and then
malfunctioning due to externalplug it back in.
electrical interference.
Unable to operate the unit from theY The path between the remote controlY Remove the obstruction.
remote control.and the remote sensor on the unit is
blocked.
Y Replace the batteries.
Y The batteries are exhausted.
� 30 �
J570V (21~31) EN305/23/0, 9:53 AM |
ACEC
