Recording
English
IMPORTANT:Recording a Tape on Deck B
Y It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
Y The recording level is automatically set correctly1Press EJECT , so it is0 for the deck B.
not affected by the VOLUME control and the
SUBWOOFER VOLUME control. Thus, during recording
you can adjust the sound you are actually listening to
without affecting the recording level.
Y While recording, you can hear sound modes through the
speakers or headphones. However, the sound is recorded
without these effects (see page 10).
Y If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance2Put in a recordable cassette, with the exposed
between the TV and the unit.part of the tape down.
Y You can use type I and II tapes for recording.
3Close the cassette holder gently.
To protect your recording
Cassettes have two small tabs on
4Check the tape direction of deck B.
the back to protect unexpectedY If the tape direction is not correct,2 3 press TAPE
erasure or re-recording.
twice then 7 to change the tape direction.
To protect your recording,
remove these tabs.
5Start playing the source N FM, AM*, CD
To re-record on a protected tape, cover the holes with
player, deck A, or auxiliary equipment
adhesive tape.
connected to AUX jacks.
When using type II tape, be careful not to cover the holes
Y When the source is CD, you can also use CD Direct
used to detect the tape type.
Recording (see page 18) and Auto Edit Recording (see
page 19).
To keep the best recording and playback sound quality
Y When the source is deck A, you can also use the
If the heads, capstans, and pinch rollers of the cassette decks
dubbing method. (See ODubbing Tapes� on page 18.)
become dirty, the following will occur:
Y Impaired sound quality* See OTo record an AM station N Beat Cut� on page 18.
Y Discontinuous sound
Y Fading6Start recording.
Y Incomplete erasureOn the unit:
Y Difficulty in recordingPress REC START/STOP.
On the remote control:
To clean the heads, capstans, and pinch rollersPress and hold REC START/STOP
Use a cotton swab moistened with alcohol.
for more than 1 second.
Pinch rollersThe REC (recording) indicator lights up on the
display and recording starts.
Capstans
To stop during recordingpress REC ST, ART/STOP again
or 7.
To remove the cassette, press EJECT 0 for deck B.
To record on both sides N Reverse Mode
Press REVERSE MODE so that the Reverse Mode
Heads
indicator lights up as N
To demagnetize the heads
Y When using the Reverse Mode for recording, start
Turn off the unit, and use a head demagnetizer (available at
recording in the forw3) direction fard (irst.
electronics and record shops).
Otherwise, recording will stop when recording is done only
on one side (reverse) of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator lights up as N
� 17 �
EN17-26.MX-J700[U]/f1700.2.17, 6:41 PM |
ACEC
