EnglishAdjusting the Voltage Selector
1Press and hold the clamp of the speaker
terminal on the rear of the unit.Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
2Insert the end of the speaker cord into the
terminal.
Match the polarity (color) of the speaker ter? tominals: VOLTAGE
? and á to á.SELECTOR
127V230V
3Release the finger from the clamp.-240V
Voltage mark
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.110V220V
Connecting Other Equipment
You can connect both analog and digital equipment.Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
Y DO NOT connect any equipment while the powervoltage where you are plugging in the unit. (See the back
is on.cover page.)
Y DO NOT plug in any equipment until all
connections are complete.
Y DO NOT plug in before setting the voltage
To connect an analog componentselector on the rear of the unit and all connection
Be sure that the plugs of the audio cords are color coded:procedures are complete.
White plugs and jacks are for left audio signals, and red ones
for right audio signals.NOW, you can plug in the unit and other
connected equipment FINALLY!
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
Y If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor (except for Argentina).
Audio/video
equipment
To stop the display demonstr press anation,y button on the
To audio outputunit or on the remote control.
For playing the other equipment through this unit,To start the display demonstration manually
connect between the audio output jacks on the otherPress and hold DEMO for more than 2
equipment and AUX jacks by using audio cords (notseconds.
supplied).
To stop the demonstr press anation, y button.
� 8 �
EN01-12.MX-J700[U]/f800.2.17, 6:38 PM |
ACEC
