Basic and Common Operations
Continued
Setting the Clock
Y When you unplug the AC power cord or if a power failure
Before operating the unit any further, first set the unitOs clock.occurs
The clock is reset to O0:00� right away. If this happens, set the
When you plug in the power cord, O0:00� starts flashing on
clock again.
the display.
Y The clock may gain or lose 1 to 2 minutes per month
You can set the clock when the unit is either turned on or in
If this happens, reset the clock.
standby mode.
YThere is a time limit in doing the following steps. If the
To show the clock when the unit is turned on
setting is canceled before you finish, start again from step 1.
On the remote control ONLY:
On the remote control ONLY:
Press DISPLAY/CLOCK SET.DISPLAY/
CLOCK SET
DISPLAY/Y Each time you press the button, the display
CLOCK SET
1When the unit is in standby mode,
changes the clock indication and the normal
press and hold DISPLAY/CLOCK
indication alternately.
SET until the hour indication starts
flashing.
To change the clock
Repeat steps 1 to 3 of the procedure OSetting the Clock.�
Y When the unit is on, press DISPLAY/CLOCK SET to
Turning On the Power
enter clock mode, then press and hold DISPLAY/
CLOCK SET.To turn on the unit, press STANDBY/ON.
STANDBY/ON
The standby lamp on the unit goes off.
2 Press 4 or c to adjustYWhen you press the source buttonNTAPE,
the hour, then pressTUNER/BAND and CD, the unit automatically
DISPLAY/CLOCK SET.turns on.
Y When you press and hold 4 or
c, the hour indication changesTo turn off the unit (standby), press STANDBY/ON
continuously.again.
DISPLAY/
The minute indication starts flashing.CLOCK SETThe standby lamp on the unit lights red.
Y O0:00� flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
YA little power is always consumed even while the unit is in
standby mode.
3 Press 4 or c to adjust
To switch off the power supply completely, unplug the AC
the minute, then presspower cord from the AC outlet.
DISPLAY/CLOCK SET.
Y When you press and hold 4 or
c, the minute indication changesWhen you unplug the AC power cord or if a power
failure occurs
continuously.
The clock is reset to O0:00� right away. If this happens, set the clock
OCLOCK OK� appears on the display for aDISPLAY/
CLOCK SETagain.
while and the built-in clock starts.
8
UX-S10[B]_C_05basic_f.p65806.3.10, 5:17 PM |
ACEC
