INSTRUCTIONSLYT0002-0L8A
English
ATTENTION:
STEREO MICROPHONEPlease note that the switch noise will be recorded if you
change the stereo angle while recording.
CU-V10U
PRECAUTIONS AND NOTES:
c The characteristics of the microphone will change if it is
dropped or subjected to shock or excessive force from
hitting it.
c During operation tests, please do not blow on the
microphone or hit it. Just talk normally into the
microphone.
c Precise parts are carefully arranged inside the microphone
for optimum use, but these characteristics can not be
retained if it is opened and disassembled. Please consult
your nearest JVC dealer or contact a service center for
Thank you for purchasing this stereo microphone. Before
repairs or maintenance.
use, please read this instruction manual carefully to ensure
c Please do not leave it near a heat source such as a stove,
proper use of this product, and keep this manual handy for
direct sunlight, or in a car with all windows closed where
future use.
the temperature gets extremely hot. Direct exposure to a
camera light will damage the microphone, causing its
color to change and its body to deform.
GENERAL BATTERY CAUTIONS:c Avoid using the microphone in places where it is
c When the battery is misused, there is a danger that it mayextremely humid, such as in a bathroom, or in areas
leak or explode.subject to oily smoke and vapor, such as near a range, as
Please read the following cautions regarding proper use.this will cause it to malfunction.
1. Insert the battery with its positive + and negative � poles
positioned correctly as indicated.
2. Do not heat, disassemble, or throw it into a fire or short-
circuit the terminals.
Please carefully read the instructions printed on the
batteries.
INFORMATION
SPECIFICATIONS
This device complies with Part 15 of FCC Rules. Operation is
Format: Electret condenser type
subject to the following two conditions:
Directivity: MS stereo with angle variation from
(1) This device may not cause harmful interference, and
0! � 120! (with a 90! click-stop)
(2) this device must accept any interference received,
Sensitivity: � 45 dB (0 dB=1 V/Pa, at 1 kHz)
including interference that may cause undesired operation.
Frequency: 100 �16,000 Hz
Change or modifications not approved by the party
Output impedance: 600 ü ?30%
responsible for compliance could void the userOs authority to
Maximum input sound
operate the equipment. This equipment has been tested and
pressure: 100 dB S.P.L or more
found to comply with the limits for a Class B digital device,
S/N ratio: 63 dB or more
pursuant to Part 15 of the FCC Rules. These limits are
Operating temperature : 0!C � 40!C
designed to provide reasonable protection against harmful
Power: DC 1.5 V ("AAA"/UM-4 battery)
interference in a residential installation. This equipment
Power consumption: Less than 1 mA (when a UM-4 is
generates, uses, and can radiate radio frequency energy and,
used.)
if not installed and used in accordance with the instructions,
Battery duration: Approx. 300 hours of continuous
may cause harmful interference to radio communications.
use (UM-4 at room temperature)
However, there is no guarantee that interference will not
Output cord: 20 cm with a gold-plated stereo
occur in a particular installation. If this equipment does
mini-plug
cause harmful interference to radio or television reception,
Dimensions: 3.6 (W) x 4.7 (H) x 12.9 (L) cm
which can be determined by turning the equipment off and
Weight: 75 g (not including the battery)
on, the user is encouraged to try to correct the interference
Provided Accessories: "AAA" battery (UM-4 for function
by one or more of the following measures:
tests)............................................. 1
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
E. & O. E. Design and specifications subject to change without notice.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help. |
ACEC
