Basic Operations
5.Adjusting the Sound Volume
To increase the volume : press [VOLUME] a (0 ž 50)
To lower the volume: press [VOLUME] ? (50 ž 0)
VOL.VOLUME
Projector:Remote
STAND BYControl panelcontrol unit
LAMPTEMPOPERATE
When OMenu display� ( page 39)
is set to O15sec�, after pressing the
PCVIDEO6-1
[VOLUME] button, the sound vol-
ume display will appear on the
V-KEYSTONE H-KEYSTONEVOL.screen for about 15 seconds.
5
(Press [EXIT] button to immedi-
EXITately remove the OAudio-Vol� dis-MENU
play.)
Audio-Vol12
ENTER
Audio-Vol 12
Screen display
Note
Y When the sound volume is displayed on the screen, pressing
the [PRESET] button will reset the set value to O0�.
PCVIDEOOPERATE
6.Power Off
6-1
1Press the [OPERATE] button on the projector (or the [OP-
W
V-KEYSTONE H-KEYSTONE SCREENDIGITALZOOMERATE] button on the remote control unit ) for 1 second or
Smore
FREEZEY The [OPERATE] indicator will disappear, the [STAND BY] in-
VOLUME FOCUSQUICK ALIGN.dicator starts to blink, and the projector goes into the cool-
down mode. The [STAND BY] indicator will continue blinking
5for approximately 90 seconds as the temperature of the light
MENUEXITsource lamp cools (Cool Down Mode).
ENTER
Turn offBlink
PRESETHIDEOPERATE
OPERATE
STAND BY
LAMPTEMPOPERATE
Projector:Remote
Projector: Indicator
Control panelcontrol unit
Note
Y The [OPERATE] button will not work for approximately 1 minute
from when the light-source lamp is turned on. Wait approxi-
mately 1 minute before pressing.
2Plug out the power cord from wall outlet
Caution
Y Please do not pull out the plug from the power source when
the [STAND BY] indicator is blinking. It will shorten the life of
the lamp and cause a malfunction.
27
HX-1E_p15-31_En.p652710/3/03, 6:08 PM |
ACEC
