Basic Operations
If projector set up is not yet complete, please read �Adjustments and Settings Using MenusO on page 32 and perform the necessary
settings.
Basic Operation Procedures
Once the basic settings are done, follow the procedures below:
1.Power On
1Insert the power cord into the wall outlet
Y The [STAND BY] indicator lights up when the main power is
inputted.
Light on
STAND BY
STAND BY
LAMPTEMPOPERATE
LAMPTEMPOPERATE
PCVIDEO1-2 Projector: Indicator
2Press the [OPERATE] button on the projector (or the [OP-
2
ERATE] button on the remote control unit) for one second
V-KEYSTONEH-KEYSTONEVOL.
or more
Y The [OPERATE] indicator lights up and the projected image
MENUEXIT
slowly appears.
Light on
ENTER
OPERATE
OPERATE
STAND BY
LAMPTEMPOPERATE
Projector:Remote
1-2 Projector: Indicator
Control panelcontrol unit
PCVIDEOOPERATE
2
Notes
W
Y Upon projection, the image may flicker for a few seconds, but
V-KEYSTONE H-KEYSTONE SCREENDIGITALZOOM
this is not a malfunction.
S
FREEZEY When the lamp is turned on, it will slowly become brighter. It
will take more than a minute for the brightness to stabilize.
VOLUME FOCUSQUICK ALIGN.
2.Selecting the image to be projected
MENUEXIT
Press [VIDEO] to select which of the image devices of those
connected to the [VIDEO IN] ([VIDEO] or [Y/C]) terminals is
ENTER
output
PRESETHIDEVIDEO
VIDEO
Projector:Remote
Control panelcontrol unit
Y Each time you press either button, the selected input changes
as follows.
Note
Y Messages are displayed in the language set[VIDEO][Y/C][VIDEO]:Image from the input [VIDEO]
by the user in the OLanguage� menu. The pre-terminal on the right hand side
set language upon purchase is OEnglish�. Theof projector will be projected.
user can choose from 8 national languages.[Y/C]: Image from the input [Y/C] ter-
minal on the right hand side of
( page 39)
the projector will be projected.
However, the input mode ([PC1], [PC2],
[PC3], [Y/C], [VIDEO]) and button indications
([FREEZE], [D.ZOOM], [EXIT]) are only dis-Notes
played in English irrespective of the displayY Sound is formed from sound signals connected to the [AU-
language setting.DIO IN] terminal.
Y When no image is input to the selected input terminal, the
message ONo Input� is displayed on the screen. ( page 53)
25
HX-1E_p15-31_En.p652510/3/03, 6:08 PM |
ACEC
