Replacing the Lamp
Resetting the lamp time
After installing a new lamp, reset the lamp time counter inside the projector when this is done. A new count will start.
If the display of the accumulated lamp time has reached 2000 hours, the projector will not work (lamp does not light up) unless the
lamp time is reset.
1.Insert the power cord into the wall outlet
Y The [STAND BY] indicator lights up when the main power is input-
ted.
2.Press the [EXIT], [HIDE], [PRESET] buttons on the remote
control sequentially, then press VOL a for 2 seconds or
more
Y The [STAND BY] and [OPERATE] indicators alternately blink about
every approx. 3 seconds. After blinking stops, lamp time resets
and the projector returns to the stand-by state ([STAND BY] indi-
cator lights up).
PCVIDEOOPERATEEXIT
W
V-KEYSTONE H-KEYSTONE SCREENDIGITALZOOM
S
FREEZE
Press for
VOLUME FOCUS2 secondsQUICK ALIGN.
HIDEPress as per normal
MENUEXIT
EXIT
ENTER
PRESET
PRESETHIDE
PRESETHIDE
Press for 2 seconds or more
VOL( )
To ensure the lamp time has been reset
The lamp time can be checked via the OLamp time� item in the OInfor-
mation� menu. ( page 32, 33, 34, 40)
Caution for reset work
Reset the lamp time only when you have replaced the lamp.
Never reset it while the lamp is still in use, otherwise the approximate
standard for gauging replacement time may be inaccurate, lamp per-
formance may suffer and lamp blow-out may also occur.
49 |
ACEC
