Filename [DR-M1EK_03Safety.fm]
DR-M1EK_03Safety.fm Page 3 Monday, September 1, 2003 3:53 PMMasterpage:Right-No-Heading
3
MOISTURE CONDENSATIONThe STANDBY/ON 1 button does not completely
Moisture in the air will condense on the unit when you
move it from a cold place to a warm place, or under shut off mains power from the unit, but switches
extremely humid conditions?just as water droplets form operating current on and off. ?`? shows electrical
power standby and ?!? shows ON.
on the surface of a glass filled with cold liquid. In
conditions where condensation may occur, disconnect
the unit?s power plug from the wall and keep it
When the equipment is installed in a cabinet or a shelf, disconnected for a few hours to let the moisture dry, then
make sure that it has sufficient space on all sides to allow turn on the unit.
for ventilation (10 cm or more on both sides, on top and
at the rear).
ATTENTION:
To mobile phone users:
When discarding batteries, environmental problems must
be considered and the local rules or laws governing the Using a mobile phone in the vicinity of the unit may
disposal of these batteries must be followed strictly.cause picture vibration on the TV screen or change
the screen to a blue back display.
On placing the unit:
Failure to heed the following precautions may result in Some TVs or other appliances generate strong
damage to the unit, remote control or disc.
1. DO NOT place the unit ?magnetic fields. Do not place such appliances on top
? in an environment prone to extreme temperatures of the unit as it may cause picture disturbance.
or humidity.
? in direct sunlight.
? in a dusty environment.IMPORTANT
? in an environment where strong magnetic fields are Connection to the mains supply in the United
generated.Kingdom.
? on a surface that is unstable or subject to vibration.DO NOT cut off the mains plug from this equipment.
2. DO NOT block the unit?s ventilation openings or If the plug fitted is not suitable for the power points in
holes.your home or the cable is too short to reach a power
(If the ventilation openings or holes are blocked by a point, then obtain a proper safety approved extension
newspaper or cloth, etc., the heat may not be able to lead/adapter or consult your dealer.
get out.)In the unlikely event of the plug fuse failing be sure to
3. DO NOT place heavy objects on the unit or remote replace the fuse only with an identical approved type,
control.as originally fitted, and to replace the fuse cover. If
4. DO NOT place anything which might spill on top of the fuse fails again consult your nearest JVC dealer.
the unit or remote control.If nonetheless the mains plug is cut off remove the fuse
(If water or liquid is allowed to enter this equipment, and dispose of the plug immediately, to avoid a
fire or electric shock may be caused.)possible shock hazard by inadvertent connection to
5. DO NOT expose the apparatus to dripping or the mains supply.
splashing.If this product is not supplied fitted with a mains
6. DO NOT use this equipment in a bathroom or places plug then follow the instructions given below:
with water. Also DO NOT place any containers filled DO NOT make any connection to the Larger Terminal
with water or liquids (such as cosmetics or medicines, coded E or Green.
flower vases, potted plants, cups, etc.) on top of this The wires in the mains lead are coloured in
unit.accordance with the following code:
7. DO NOT place any naked flame sources, such as
lighted candles, on the apparatus.Blue to N (Neutral) or Black
8. AVOID violent shocks to the unit during transport.Brown to L (Live) or Red
If these colours do not correspond with the terminal
identifications of your plug, connect as follows:
Blue wire to terminal coded N (Neutral) or coloured
Black.
Brown wire to terminal coded L (Live) or coloured
Red.
If in doubt ? consult a competent electrician.
Page 3September 1, 2003 3:39 pm |
ACEC
