TROUBLESHOOTING
Solutions to common problems related to your monitor are described here. If none of the solutions presented here solve
the problem, unplug the monitor and consult a JVC-authorized dealer or service center for assistance.
Reference
ProblemsPoints to be checkedMeasures (Remedy)pages
No power supplyIs the power plug loosened orFirmly insert the power plug.N
disconnected?
Is the main power turned OFF?Turn the main power ON.6
No picture withIs the signal cable disconnected?Connect the signal cable firmly.7 ~ 10
the power onIs the power of the connectedTurn on the power of the connected component
component ON?and set it correctly.N
Is the signal output from the connected
component?
Is the input signal selected correctly?Select the correct input with the INPUT SELECT5
buttons.
Is the input signal adapted to theCheck that the input signal format corresponds to7 ~ 10
monitorOs specification?the installed input card format.
Are any of the self-check indicatorsFollow the procedures in OSELF-CHECK
(INPUT SELECT A through F buttons)INDICATIONS�.27
blinking?
No soundIs the audio cable disconnected?Connect the audio cable firmly.7 ~ 10
Is the audio signal output from theSet the connected component correctly.
connected component?N
Is the volume output set to minimum?Adjust the speaker volume with the VOLUME4
(volume adjustment) buttons.
Wrong colorHas the picture adjustment beenSet each picture adjustment knob to the standard
changed?(centered) position. Or, set each picture
adjustment item in [PICTURE SUB ADJ.] in the4, 20
<SETUP MENU> screen to Standard (00) (or
use the [reset] function).
Has the WHITE BALANCE settingSet each [COLOR TEMP./BAL.] item in the
been changed?<SETUP MENU> screen to Standard (000) (or20
use the [reset] function).
Are any cables connected to theConnect each signal cable firmly.
component/RGB input card?7
Has the correct signal been input to theSelect INPUT A/C/E when the component signal
component/RGB input card and theis input, or select INPUT B/D/F when the RGB7
correct INPUT been selected on thesignal is input.
monitor?
Unnatural pictureHas [CONTRAST] or [BRIGHT] beenAdjust the CONTRAST or BRIGHT picture
changed?adjustment knobs.
Or, adjust the [CONTRAST] or [BRIGHT] item in4, 20
[PICTURE SUB ADJ.] in the <SETUP MENU>
screen.
Shaking pictureIs the monitor close to a motor,Move the monitor away from the device until the
transformer or any other devicepicture stops shaking.
generating a strong magnetic field?Connect the power plug to another AC outletN
(a fan, fluorescent light, laser printer,away from the former one.
another monitor, etc.)
25
LCT1424-001A_EN_p18-322511/4/03, 5:13 PM |
ACEC
