To remove the WS antenna from the
Connecting the WS antenna
housing platform
For safety reasons, make sure that the unit is notPull up on the front end of the antenna unit to unlock
plugged in and batteries are not installed whenthe base. The WS antenna should then be easily
making connections.removable.
To install the WS antenna
1. To install the WS antenna, orient the antenna by
LITE ANTENNA SYSTEM
lining up the arrow marks on the front of the WS
antenna and on the front side of the housingON /STANDBY
VOLUME
PRESET
platform. Slide the antenna into the housingSOUNDAUTO PRESETWSLEARNPTYPASSWORDMULTI/LANGTUNING / SELECTBANDMEMORY/ CANCEL
platform at an angle so that the groove on the
back side of the base of the antenna fits into theCAUTION:
corresponding tab on this unit.DO NOT FORCE THE WS ANTENNA INTO OR OUT
OF THE HOUSING PLATFORM. THIS MAY CAUSE
DAMAGE TO THE WS ANTENNA AND CAUSE THIS
UNIT TO PERFORM IMPROPERLY.
ACE ANTENNA SYSTEM
\
ON /To connect the extension cable.STANDBYVOLUME
PRESET
SOUNDAUTO PRESETWSLEARNPTYPASSWORDMULTI/LANGTUNING / SELECTBANDMEMORY/ CANCEL1. Disconnect the WS antenna from the antenna
jack.
2. Push down on the front end of the base of the2. Connect the extension cable into the antenna jack
antenna until it clicks into place.on the rear panel of the unit.
3. Slide the rain protection cover on the extension
cable back so that the connector protrudes.
PACE ANTENNA SYSTEM
ON /STANDBYVOLUME
PRESET
SOUNDAUTO PRESETWSLEARNPTYPASSWORDMULTI/LANGTUNING / SELECTBANDMEMORY/ CANCEL
4. Firmly connect the extension cable with the WS
antenna cable.
To connect the antenna cable
Connect the antenna cable to the antenna jack
located on the rear panel of the unit.
5. Slide the rain protection cover over the
ANTENNAconnected section completely for best
EXTERNALperformance.
WARNING
Y DO NOT PUT BATTERY IN BACKWARDS, MIX WITH USED OR OTHER BATTERY TYPES-MAY EXPLODE OR LEAK AND CAUSE PERSONAL INJURY.
Y REMOVE THE BATTERIES ("D" SIZE, R20) WHEN USING THE AC POWER.
Y SEE INSTRUCTION MANUAL.
Notes:CAUTION:
Y Be sure not to place the back of this unit against a wall orThe rain protection cover is not intended to be left
other surface when the antenna cable is connected as it
out in heavy rain or submerged in water. Please
may damage the cable and/or antenna jack.
avoid exposing this section of the cable to excessive
Y Be sure to check that the cable under and not over the
moisture.
handle of the unit. If the cable is over the handle, using
the handle to carry this unit may be the cause of
malfunction.Notes:
Y To help ensure long-lasting performance of this unit, do
not leave the extension cable and antenna outside or in
direct sunlight for long periods of time. It is
recommended that you restore the WS antenna to the
housing platform when you are finished using the unit.
Y The WS specified extension cable supplied with this unit
is specially designed for use with this unit. Should you
use a cable not supplied with this unit nor recommended
by JVC for use with this unit, JVC cannot guarantee the
performance of this unit. For details regarding
compatibility with this unit, please consult with the
manufacturer of the cable.
To adjust the WS antenna
For details on how to position the WS antenna for
best possible reception, refer to page 9.
5
FR-DS100.02-0855/5/99, 12:46 PM |
ACEC
