Basic and Common Operations
Continued
English
Setting the ClockTo select 12-hour or 24-hour clock system
You can select 12-hour or 24-hour for the clock system only
Before operating the unit any further, first set the unitOs clock.while the unit is in standby mode.
When you plug in the power cord, OAM12:00� starts flashing
on the display.
On the unit ONLY:
You can set the clock when the unit is either turned on or in
standby mode.To change the clock setting, press
Y In the following procedure, the clock is set to 12-hourTIMER ON/OFF while holding down 7.CD
CONTROL
system.
Y Each time you press TIMER ON/OFF,
On the remote control ONLY:the clock change alternates betweenTIMER ON/OFF
12-hour and 24-hour system.
PROGRAM
1When the unit is in standby mode,
press and hold PROGRAM until the
hour indication starts flashing.To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY/CLOCK SET.DISPLAY/CLOCK SET
Y Each time you press the button, the display
Y When the unit is on, press DISPLAY/CLOCK SET tochanges the clock indication and the normal
enter clock mode, then press and hold PROGRAM.indication alternately.
2Press 4 or c to adjust
the hour, then pressTo change the clock
PROGRAM.Repeat steps 1 to 3 of the procedure OSetting the Clock.�
Y When you press and hold 4 or
c, the hour indication changes
continuously.
PROGRAM
The minute indication start flashing.
Turning On the Power
To turn on the unit, press STANDBY/ON.
STANDBY/ON
The STANDBY lamp on the unit goes off.
Y When you press the source buttonNTAPE,
TUNER/BAND and CD, the unit automatically
3 Press 4 or c to adjustturns on.
the minute, then press
PROGRAM.To turn off the unit (standby), press STANDBY/ON
Y When you press and hold 4 oragain.
c, the minute indication changesThe STANDBY lamp on the unit lights red.
continuously.Y OAM12:00� flashes on the display until you set the built-in
The built-in clock starts.PROGRAMclock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
Y A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
Y When you unplug the AC power cord or if a power failureWhen you unplug the AC power cord or if a power
occursfailure occurs
The clock is reset to OAM12:00� right away. If this happens, setThe clock is reset to OAM12:00� right away. If this happens, set the
the clock again.clock again.
Y The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
8
FS-H10[C]basic.p65803.6.11, 9:45 AM |
ACEC
