AM antennaConnecting Speakers
2
]]
1
3
ANTENNA
Vinyl-covered wire
(not supplied)
1RedGray
AM EXT
AM LOOP
RIGHTLEFTRIGHTLEFT
MAIN
SPEAKERS
FM 75SUBWOOFERS
COAXIALSPEAKERSPEAKER
IMPEDANCEIMPEDANCE
MIN 6MIN 6
Blue
Black
Speaker cords
Speaker cords
2
AM loop antenna
(supplied)
1Connect the AM loop antenna to the AM
LOOP terminals as illustrated.BlackBlueBlackBlue
RedGrayRedGray
Y If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it asRight speakerLeft speaker
shown in the diagram.
1Press and hold the clamp of the speaker
2Turn the AM loop antenna until you have the
terminal on the rear of the unit.
best reception.
2Insert the end of the speaker cord into the
To connect an outdoor AM antenna
terminal.
When reception is poor, connect a single vinyl-covered wire
Match the polarity of the speaker terminals: Red (+) to
to the AM EXT terminal and extend it horizontally. (The AM
red (+) and black (�) to black (�), gray (+) to gray (+) and
loop antenna must remain connected.)
blue (�) to blue (�).
Y Remove the vinyl covering the wire by
twisting it as shown in the diagram.
For better reception of both FM and AM
Y Make sure the antenna conductors do not touch an3y otherRelease the finger from the clamp.
terminals and connecting cords.
Y Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
� 7 �
EN01-11.FS-P7[J]701.5.21, 11:58 AM |
ACEC
