FS-SD550(J)/ GNT0008-001A/ English
FS-SD5_01E.book Page 9 Tuesday, February 13, 2001 12:02 PM
Basic Operations
REMOTE CONTROL DIMMERSLEEPPOWER
DIMMERAUTOPOWER
DISPLAY PRESETFM MODE
DISPLAYTop Cover
PROGRAMRANDOMREPEATMD/AUXFM/AMPRESETTUNINGAHB PRO
CLOCK TIMERVOLUME
AHB PRODOORSLIDECDDOWNCDMULTI CONTROLUP
AHB PRO
BASSTREBLE CANCELDOOR SLIDE
BASS
UPTREBLE
AHB PROCLOCK VOLUME+,-
SET
FADEDOWN
FADE MUTINGPOWERSTANDBY/ONOPEN/CLOSE
MUTINGMD/AUXCDFM / AM
PHONES
VOLUME+,-VOLUME
STANDBY/ON indicator
POWERPHONES
When the System is Turned Off
Turning the Power On and Off
(STANDBY MODE)
Each time you press the DIMMER button on the Remote
Turning the System On
Control, the brightness of the backlighting changes as fol-
Press the POWER button.lows:
The Top Cover moves backward and the Unit?s top buttons
No backlightin=g Dark backlighting
appear. The display comes on and ?HELLO? is displayed
= (back to the beginning)
once. The STANDBY/ON indicator ligreenght.s in
The System comes on ready to continue in the mode it was
in when the power was last turned off.
?When the System is turned off again after power on, the
n For example, if the last thing you were doing was listen-
brightness in Standby mode will be restored to the previ-
ing to a CD, you are now ready to listen to a CD again. If
you wish, you can change to another source.ous one since the brightness setting in Standby mode is
stored in memory.
n If you were listening to the Tuner last, the Tuner comes
on playing the station it was last set to.
Turning the System OffAdjusting the Volume
Press the POWER button again.
Press the VOLUME + button to increase the volume or
The Top Cover moves back to the original position.
press the VOLUME - button to decrease it.
?GOOD BYE? is displayed and the display goes out, except
for the clock display. The STANDBY/ON indicator lights in
red.
n Some power is always consumed even though power is
turned off (called Standby Mode).
You can adjust the volume level between 0 and 50.
n To switch off the System completely, unplug the AC
power cord from the wall outlet. When you unpluCAUTIg the ON:
AC power cord, the clock will be reset to AM 12:00 after
? DO NOT turn on the System and/or start
about 20 minutes.
playing any source without first setting the
VOLUME control to minimum, as a sudden
blast of sound could damage your hearing,
Adjusting the Brightness
speakers and/or headphones.
(DIMMER)
For private listening
You can adjust the brightness of the backlighting for the dis-
Connect a pair of headphones to the PHONES jack. No
play.
sound comes out of the speakers.
Be sure to turn down the volume before connecting or put-
When the System is Turned On
ting on headphones.
Each time you press the DIMMER button on the Remote
Control, the brightness of the backlighting changes as fol-
lows:
Bright = Dark = (back to the beginning)
9 |
ACEC
