CAUTION: Make all connections before plugging the System into an AC power outlet.
Connecting the Speakers
English
For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System.
1. Open each of the terminals and insert the speaker wires firmly, then close the terminals.
2. Connect the red (+) and black (�) wires of the right side speaker to the red (+) and blacem.k (�) terminals marked R on the Syst
Connect the red (+) and black (�) wires of the left side speaker to the red (+) and black (�) terminals marked L on the System.
Right speaker (rear side)Left speaker (rear side)
Black
L
R
SPEAKERS
IMPEDANCE
MIN 4W
CAUTION:
If a TV is installed near the speakers, the picture on the TV may be distorted. If this happens, set the
speakers away from the TV.
Connecting External Equipment
Connect signal cords (not supplied) between the SystemOs LINE IN (AUX)/LINE OUT terminals and the output/input terminals of an
external MD recorder, cassette deck, etc.
You can then listen to the external source through the System, or record the SystemO es CD plaxternal unit.yer, cassette tape, or tuner to the
Signal cord (not supplied)
To audio input
Pin-plug x 2Pin-plug x 2
MD recorder orLINE OUT
RL
cassette deck (not supplied)
Signal cord (not supplied)LINE IN
(AUX)
To audio output
Pin-plug x 2Pin-plug x 2
Connecting an MD Recorder, etc. (Digital Output)
Unplug the cap and connect an optical digital cord (not supplied) between the SystemOs OPTICAL DIGITutAL OUT terminal and the inp
terminal of an MD recorder, etc.
You can record the digital output signal from the SystemOs CD Player to the MD recorder, etc.
Cap
MD recorder, etc. (not supplied)
To optical digital
OPTICALinput
DIGITAL OUTOptical digital cord (not supplied)
4
EN01-09.FS-V30[J(C)]400.3.27, 6:18 PM |
ACEC
