FS-X1-3(B)_E.book Page 1 Friday, March 28, 2003 2:55 PM
Warnings, Cautions and Others
IMPORTANT for the U.K.Caution ?STANDBY/ON button!
Disconnect the main plug to shut the power off completely. The
DO NOT cut off the mains plug from this equipment. If the
plug fitted is not suitable for the power points in your homeSTANDBY/ON button in any position does not disconnect
or the cable is too short to reach a power point, then obtainthe main line. The power can be remote controlled.
an appropriate safety approved extension lead or consult? When the unit is on standby, the STANDBY/ON indicator lights
your dealer.red.
When the unit is turned on, the STANDBY/ON indicator lights
BE SURE to replace the fuse only with an identical
approved type, as originally fitted.green.
If nontheless the mains plug is cut off ensure to remove the
fuse and dispose of the plug immediately, to avoid a possi-IMPORTANT FOR LASER PRODUCTS
ble shock hazard by inadvertent connection to the mains
supply.CLASS 1 LASER PRODUCT
CAUTION
If this product is not supplied fitted with a mains plug then
follow the instructions given below:1 Invisible laser radiation when open and interlock failed or
defeated. Avoid direct exposure to beam.
IMPORTANT:CAUTION
DO NOT make any connection to the terminal which is1 Do not open the top cover. There are no user serviceable
marked with the letter E or by the safety earth symbol orparts inside the unit; leave all servicing to qualitied service
coloured green or green-and-yellow.personnel.
The wires in the mains lead on this product are coloured in2 Use of controls, adjustments or performance of procedures
accordance with the following code:other than those specified herein may result in hazardous
Blue :Neutralradiation exposure.
Brown :LiveCAUTION
1 Do not block the ventilation openings or holes. (If the venti-
As these colours may not correspond with the coloured
lation openings or holes are blocked by a newspaper or
markings identifying the terminals in your plug proceed ascloth, etc., the heat may not be able to get out.)
follows:
2 Do not place any naked flame sources, such as lighted
The wire which is coloured blue must be connected to thecandles, on the apparatus.
terminal which is marked with the letter N or coloured black.3 When discarding batteries, environmental problems must
The wire which is coloured brown must be connected to thebe considered and local rules or laws governing the dis-
terminal which is marked with the letter L or coloured red.posal of these batteries must be followed strictly.
IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.4 Do not expose this apparatus to rain, moisture, dripping or
splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
CAUTION
To reduce the risk of electric shocks, fire, etc.:
CAUTION
1 Do not remove screws, covers or cabinet. About the Internal Cooling Fan
2 Do not expose this appliance to rain or moisture.
This unit includes an internal cooling fan, so as to allow for
Caution: Proper Ventilationhigh-power operation within a small space.
To avoid risk of electric shock and fire, and to prevent damage,This fan comes on when the sound level is set high, and
locate the apparatus as follows:may also come on even at low sound levels if the internal
1 Front: No obstructions and open spacing.temperature rises. To ensure effective fan operation, please
2 Sides/ Top/ Back : No obstructions should be placed in theleave at least 15cm clearance between the rear of the unit
areas shown by the dimensions below.and the wall, and at least 1cm clearance on each side of the
3 Bottom: Place on the level surface. Maintain anunit.
adequate air path for ventilation by plac-
ing on a stand with a height of 10 cm or
more.
Front viewSide viewFront viewSide view
15 cm15 cm
15 cm1 cm1 cm15 cm
15 cm
10 cm
FS-X1CA-FSX1FS-X3CA-FSX3
G-1 |
ACEC
