Connecting an external control unit
When connecting the external control unit to the MAKE terminal, you can operate the following functions through the
MAKE terminal;
Y Turn on or off the Monitor.
Preparation: ThePOWER switch on the rear must be set to ON (so that the Monitor is in standby mode).
Y Select the input.
Preparation: OREMOTE SWITCH� should be set correctly to select your desired input (see page 26).
Notes:
Y There is no remote control on/off switch. When a plug is inserted to the MAKE terminal, remote control through the
external control unit is automatically activated.
Y When the other REMOTE terminals are used at the same time, transmitted commands through the MAKE terminal have
priority over those through the other terminals.
Y MAKE terminalY External control unit
Pin numberSignal name
Signals
65
1GNDtransmitted
43
2GND
TTL level
213SW2aaaa
=H: Power OffL: Power On
4SW1aaaa
=H: Input A*L: Input B*
5SW DETaaaa
=H: Not connectedL: Connected
6GND
* Input A and Input B will be determined by the OREMOTE
SWITCH� setting.
IMPORTANT:
External control unit is not commercially available in the market. When you need it, consult your dealer.
Connecting the Cooling Fan Unit (not supplied)
When installing this Monitor vertically, it is required to attach the Cooling Fan Unit.
Note: If you install the Monitor in such a way not instructed in this manual (for example, installing it diagonally), the
Cooling Fan Unit may not be able to cool down the internal heat enough to make the Monitor operate; therefore,
reinstallation or another method for cooling will be required.
Y For more detailed connection, refer to the manual supplied with the Cooling Fan Unit.
Cooling Fan Unit
OPTION
POWER
AC IN
OUTLROPTIONAUDIO
MAKEWIRED
RS-232C
AUDIOINREMOTESPEAKER OUTL 9(
RGB A
IMPORTANT:
When installing the Monitor
vertically, consult your dealer.
13
04-13.GM-P420[US]f1302.4.1, 2:18 PM |
ACEC
