USING THE REMOTE CONTROL UNIT (cont.)
44 EN
SELECT SCENES
Remote sensor
START SOURCE PLAYBACK
4Press PLAY, then press ON/OFF on the remote
control. Make sure to point the remote control at the
camcorderOs remote sensor.
YThe R.A. Edit counter display appears.
REGISTER BEGINNING OF SCENE
5Press REW or FF to locate the beginning of the scene
you want, then press IN/OUT to register that point.
YThe data appears under OIN� on the display.
REGISTER END OF SCENE
6Press REW or FF to locate the end of the scene and
press IN/OUT to register it.
Power Switch
YThe data appears under OOUT� on the display.
YThe total time of the registered scene(s) is displayed
FF
REWat the bottom of the screen.
PAUSE
PLAY
CANCEL
IN/OUTREGISTER ADDITIONAL SCENES
ON/OFF7Repeat steps 5 and 6 for each additional scene
(as many as 8).
RM-V700U
(provided with GR-AX501/AX401,
optional for GR-AX301/AX201)MAKE CORRECTIONS (IF NECESSARY)
8Press CANCEL during steps 5 and 6 to erase the most
IN OUT recently registered point.
10:00:25--:--:--
2NOTES:
3
4cThere must be at least one second between an in-point
5
6and its corresponding out-point.
7cTo ensure correct operation, there should be at least
8
COUNTER 0:00:25 15 seconds between an out-point and the next in-point.
TOTAL 0:00:00
cBlank portions of a tape cannot be registered as in-points
or out-points.
IN OUT cIf it takes more than 5 minutes to search for an in-point,
10:00:250:01:05
20:03:180:03:31the VCROs Record-Pause mode is cancelled and editing
30:02:330:02:53does not take place.
40:04:11--:--:--
5 cPressing ON/OFF clears all in- and out-points from
6
7memory.
8cLeave a small margin for error around each in-point to
COUNTER 0:04:11
TOTAL 0:01:13ensure the scene is recorded in its entirety.
cTurning off the camcorderOs power erases all registered
in- and out-points. |
ACEC
