EN 13
Tape remaining time indicator
STOP RECORDING
25MINMINPress the Recording Start/Stop Button again to stop
(Now calculating)4recording.
YThe camcorder re-enters the Record-Standby
60MIN
mode.
59MINNOTES:
cWhen the Power Switch is set to CAMERA and the LCD
monitor is opened at an angle of 45 degrees or more, the
3MIN
LCD monitor switches on and the viewfinder switches
off automatically to save power.
2MINcA cassette holder canOt be opened unless a power supply
(Blinking)is attached.
cThere may be a delay after you press EJECT until the
holder opens. Do not use force.
1MIN
cThe tape remaining time is only displayed in the
(Blinking)
viewfinder as shown.
cThe remaining time indicated in the viewfinder is
0MIN
approximate.
(Blinking)
cThe time required to calculate the remaining tape
length, and the accuracy of the calculation, may vary
Start/Stop Buttonaccording to the type of tape used.
cThe tape remaining time indicator is correct only if the
correct tape length has been selected (Z pg. 8).
cOTAPE END� appears when the tape reaches its end,
and the power goes off automatically if left in this
condition for 5 minutes. OTAPE END� also appears
when a cassette whose tape is already at its end is
loaded.
cIf the Record�Standby mode continues for 5 minutes
without performing Zoom or any other operations, the
camcorderOs power shuts off automatically. Set the
Power Switch to OPOWER OFF�, and then back to
OCAMERA� to turn the camcorder on again.
cIf the Recording Start/Stop Button is pressed after the
Record-Standby mode has continued for over
5 minutes, recording may not start immediately.
cIf youOre recording on a cassette from the middle (such
as when a tape is removed and re-inserted during
recording), use the Retake function (Z pg. 17) to find
the end of the last recording so you donOt erase any of
it.
cThe LENS COVER warning blinks for about 5 seconds
when the camcorder is turned on when the cover is
closed.
cWhile shooting, sound is not heard from the speaker. |
ACEC
