RECORDING Basic Features
11
Zoom indicatorFEATURE:Zooming
PURPOSE:To vary the length of the focal lens and
Zoom-in
produce zoom in/out effect.
TTTTOPERATION:Zoom In
1) Pull the power zoom switch down
WWWWtoward OT�.
Zoom Out
2) Push the switch up toward OW�.
Zoom-out
NOTES:cThe further the power zoom switch is
pushed or pulled, the faster the zoom
speed becomes.
cFocusing may become unstable
during zooming. In this case, set
RETAKEzoom while in Record�Standby, set
manual focus or Focus Lock
(Z pg. 18, 19), then zoom in or out
in Record mode.
FEATURE:Quick Review
PURPOSE:To check end of last recording for
Power zoom switchconfirmation.
OPERATION: 1) Press O � for less than 2 seconds
during Record�Standby mode.
YTape is rewound for about 2
seconds and played back automati-
cally, then pauses in Record�
Standby mode for next shot.
NOTE:Distortion may occur at start of
playback. This is normal.
FEATURE:Retake
PURPOSE:To re-record certain segments.
OPERATION: 1) Make sure camcorder is in Record�
Standby mode.
2) Press either RETAKE button to reach
start point for new recording.
3) Press Recording Start/Stop to start
recording.
NOTE:Noise may appear during Retake. This
is normal. |
ACEC
