RECORDING Advanced Features
26
Self-Timer
Tally lamp PROGRAM AE
You can set the delay between pressing Recording Start/
Stop and the actual start of recording. If you secure the
camcorder, you (or whomever is operating the
camcorder) can enter the scene before recording starts.
NOTE:
You need the RM-V705U or RM-V700U remote control
unit to perform this procedure.
ENGAGE RECORD�STANDBY
MODE
Make sure the lens cover is open, set the power
1switch to CAMERA.
SET TIME DELAY
On the remote control, press INT. TIME to set the
START/STOP
2delay time. There are four choices, and they appear
INT. TIME
in the viewfinder in the following order (each time
REC TIMEINT. TIME is pressed): 15S (15 seconds), 30S
(30 seconds), 1MIN (1 minute) and 5MIN
(5 minutes). Pressing again releases the Self-timer.
START DELAYED RECORDING
RM-V700URM-V705U (provided
ORPress Recording Start/Stop. The tally lamp begins
(optional)with GR-AX610 only)
3blinking, and the blinking speed increases about
5 seconds before recording starts. When recording
begins, the lamp stops blinking but stays lit.
RELEASE SELF-TIMER MODE
To release when the tally lamp is not blinking, press
4INT. TIME continuously until O � disappears. To
release when the tally lamp is blinking, press
Recording Start/Stop to stop the blinking, then press
INT. TIME continuously until O � disappears.
NOTE:
If the PROGRAM AE dial is set to O �, 15S is
automatically selected. |
ACEC
