40USING REMOTE CONTROL UNIT (cont.)
Insert Editing
COUNTER R/MYou can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V704U or RM-V700U remote control unit to
perform this procedure.
SELECT MODE
Set the Power switch to OPLAY�.
1
FIND EDIT-OUT POINT
Play back the tape, locate the point and press
2PAUSE on the camcorder or the remote control.
POWERRESET COUNTER
Press and hold COUNTER R/M for more than
32 seconds to reset the tape counter, then press for
M-0:23:45Tape Counterless than 1 second and make sure OM� appears in
the viewfinder.
FIND EDIT-IN POINTInsert editing indicator
Press REW to go a little beyond the beginning of the
Viewfinder4scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE at exactly at the
point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing
5INSERT, press and release PAUSE. The Insert
mode is engaged. When the scene the camcorder is
aimed at appears on the screen go to the next step.
BEGIN INSERT EDITING
Press RECORDING START/STOP. When the counter
6reaches O0:00:00�, editing stops automatically and
the camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP.
7START/STOP
REW
PAUSENOTES:
cAfter step 5, Retake (Z pg. 13) can be performed.
INSERT
cThe tape may stop slightly before or after the
PLAYdesignated end point, and noise bars may appear.
Neither indicates a defect in the unit.
cOnly video signal is recorded in the Insert EditingRM-V704U or RM-V700U
(provided with GR-AX770,
mode.optional for GR-AX670) |
ACEC
