EDITING (cont.)
42
REW/FF CANCELPREPARE CAMCORDER
IN/OUTInsert a recorded tape and set the Power switch to
2OPLAY�.
R.A. EDIT
PREPARE VCR
PLAY/PAUSETurn the power on, insert a recordable tape and
3engage the AUX mode (refer to VCROs instructions).
STOP
SELECT SCENES
ACCESS R.A. EDIT COUNTER
DISPLAY
Press PLAY/PAUSE, then press R.A. EDIT and the
1counter display appears in the viewfinder and the
screen of the connected TV.
To JLIPTo AUDIO and
REGISTER BEGINNING OF SCENE
VIDEO outPress REW or FF to locate the beginning of a scene
connectors
2you want, then press IN/OUT to register that point.
Editing cable
The data appears under IN on the display.
(optional 3.5 ż
mini-plug cable)Audio and Video
cable (optional)REGISTER END OF SCENE
ACPress REW or FF to locate the end of the scene and
B3press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
To RemoteTo AUDIO and
PAUSEVIDEO IN
REGISTER ADDITIONAL SCENES
connectors
To Pause-InRepeat steps 2 and 3 for each additional scene
4(as many as 8).
VCR (Recording deck)MAKE CORRECTIONS
Press CANCEL during steps 2 and 3 to erase the
5most recently registered point.
CANCEL
RM-V700U
NOTES:
(optional)
cThe RM-V700U can be used to operate other camcorder
ON/OFFfunctions as well. Point the RM-V700U at the camcorderOs
remote sensor and press any of the following buttons
VCR REC STBY
(function apears in parentheses):
IN/OUTN ON/OFF (camcorder R.A. EDIT)
N IN/OUT (camcorder IN/OUT)
IN OUT
IN OUT
N CANCEL (camcorder CANCEL)
ç 1 0:00:25 --:--:--
ç 1 0:00:25 0:01:05
cThere must be at least one second between an in-point and
2
2 0:03:18 0:03:31
3
3 0:02:33 0:02:53
its corresponding out-point.
4
4 0:04:11 --:--:--
5
5
cTo ensure correct operation, leave at least 15 seconds open
6
6
7
7
between scenes.
8
8
cBlank portions of tape cannot be registered as in-points or
COUNTER 0:00:25
COUNTER 0:04:11
TOTAL 0:00:00 TOTAL 0:01:13out-points.
cIf it takes more than 5 minutes to search for an in-point, the
VCROs Record-Pause mode is cancelled and editing doesnOt
take place.
cPressing R.A.EDIT clears all in- and out-points from
memory.
cLeave a small margin for error around each in-point to
ensure the scene is recorded in its entirety. |