EN 5
NOTES:
cThe recording time per charge is affected by such factors as the time spent in Record/Standby mode and
the frequency of zooming. It is safer to have spare battery packs.
cCharging times noted on page 4 are for fully discharged battey pack, and discharging times are for fully
charged battery pack.
cCharging and discharging times vary according to the ambient temperature and the status of the battery pack.
cRemember to set the charge marker after charging a battery pack or after detaching a discharged one from
your camcorder.
cPerform the REFRESH function after no less than 5 chargings.
cHigh temperatures can damage the battery pack, so use only where good ventilation is available. DonOt
allow it to discharge in container, such as a bag.
cIf you stop recharging or discharging part way through, make sure to remove the battery pack before
unplugging the adapterOs AC cord.
cRemove the battery pack from the adapter immediately after discharging.
cTo avoid interference with reception, do not use the AC Power Adapter/Charger near a radio.
cMake sure you unplug the DC cord before charging or discharging the battery pack.
cA blinking CHG. indicator means that the battery pack has become hot. Wait until it cools down to continue.
cThe CHG. indicator may not light properly with a brand new battery pack, or with one thatOs been stored
for an extended period. In this case, remove and reattach the battery pack and recharge it. The CHG.
indicator should light during recharging. If not, contact your nearest JVC dealer.
USING A CAR BATTERY
To AC outletUse the optional Car Battery Cord or Car Battery
DC OUTCharger/Adapter (connect as shown in the
terminal
illustration to the left).
To DC
in jackNOTES:
cWhen using the car battery, leave the engine
AC Power
idling.
Adapter/Charger
cThe optional Car Battery Charger (BH-V3E) can
DC cordAA-V11EGalso be used to charge the battery pack.
cWhen using the optional Car Battery Charger or
Car Battery Cord (AP-V7E), refer to the respective
To carOs
instruction booklet.
cigarette
lighter
socketUSING AC POWER
Car Battery Cord
AP-V7E (optional)Use the AC Power Adapter (connect as shown in
the illustration to the left).
NOTE:
The supplied AC Power Adapter/Charger features
automatic voltage selection in the AC range from
Car Battery Charger/Adapter110 V to 240 V.
BH-V3E (optional) |