TROUBLESHOOTING (cont.)
44 EN
SYMPTOMPOSSIBLE CAUSE(S)
OTHER
During recording, the indications doc Press DISPLAY for longer than 1 second to make the
not appear.indications appear (Z pg. 17).
The tape will not eject.c The battery pack is running low.
Some functions are not available.c The Power Switch is set to OAUTO�.
c Certain combinations of modes or effects are not possible
to use.
Vertical white lines appear whenc This sometimes occurs when the contrast between the
shooting a very bright object.background and the object is great. It is not a defect of the
camcorder.
Bright, crystal-shaped spots appear inc Sunlight is directly entering the lens. This is not a defect of
the viewfinder.the camcorder.
Colored bright spots appear all overc The viewfinder is made with high-precision technology.
the viewfinder.However, black spots or bright spots of light (red, green or
blue) may appear constantly in the viewfinder. These spots
are not recorded on the tape. This is not due to any defect
of the unit. (Effective dots: more than 99.99 %.)
The viewfinder and the lens havec Wipe them gently with a soft cloth. Gently wipe in a
become dirty (ex. fingerprints).semicircular motion, as wiping strongly spreads the stain
and it wonOt come out easily.
The picture is blurred in the Quickc This is normal while recording in the EP mode. Some noise
Review or Retake mode.may be present while recording in the SP mode (Z pg. 12).
An error number (i.e. E03) appears.c Turn the camcorderOs power off, then disconnect the power
source. After a few minutes, try turning the power on again.
If the error number still appears in the viewfinder, consult
your nearest JVC dealer.
The image is out of focus.c The diopter needs to be adjusted (Z pg. 14).
c The scene being shot is adversely affecting the operation of
Auto Focus (Z pg. 30).
The date and time displaysc If you remove the power source from the camcorder while
disappear.the power is on, all settings and selections are erased. Make
sure to turn the camcorderOs power off before disconnecting
the power source.
The wrong date and time arec If you have not performed Date/Time Setting (Z pg. 11),
displayed/recorded.the date and time are not displayed/recorded correctly. Be
sure that Date/Time setting is carried out.
Even though the lens cover is open,c The Lens Cover Warning indicator may blink when the
the Lens Cover Warning indicatorcamcorder is used in dark areas, regardless of the position
blinks.of the lens cover. |
ACEC
