GETTING STARTEDUSING THE BATTERY PACK
Perform step 1) of OCHARGING THE BATTERY
Hook on.PACK�.
Approximate recording time (unit: min.)
Battery packViewfinder on
BN-V10U100
Push in. BN-V12U110
(optional)
BN-V20U170
(optional)
BATTERY RELEASE SwitchPower Switch BN-V400U410
(optional)
Battery packUSING AC POWER
Connect the AC Adapter to the camcorder ( step
2) and 3) of OCHARGING THE BATTERY PACK�).
YThe provided AC Adapter features automatic
voltage selection in the AC range from 110 V to
To DC IN240 V.
connector
ATTENTION
AC Adapter
To AC outletBefore detaching the power source, make sure
that the camcorderOs power is turned off. Failure to
do so can result in a camcorder malfunction.
CHARGING THE BATTERY PACK
1) Hook the end of the battery pack to theREFRESH:
Be sure to fully discharge a battery pack before
camcorder and push the battery in until it locks
in place.recharging otherwise the battery performance will
YIf the battery pack is attached in the wrongbe reduced.
1) Perform steps 1) through 3) of OCHARGING
position, a malfunction may occur.
2) Set the Power Switch ! to OOFF� while pressingTHE BATTERY PACK�.
2) Press REFRESH ( for over 2 seconds. The
down the Lock Button 0 located on the switch.
Connect the AC Adapter to the DC IN connectorPOWER lamp @ blinks to indicate discharging
has started.
8.3) When discharging is finished, charging
3) Plug the AC Adapter into an AC outlet. The
CHARGE lamp * blinks to indicate chargingautomatically starts and the CHARGE lamp *
blinks.
has started.
4) When the CHARGE lamp * stops blinking but
stays lit, charging is finished. Unplug the AC
Adapter from the AC outlet. Disconnect the AC
Adapter from the camcorder.
To Detach The Battery Pack . . .
... slide BATTERY RELEASE 7 and pull out the
battery pack.
Battery packCharging time
BN-V10Uapprox. 1 hr. 30 min.
BN-V12U (optional)approx. 1 hr. 40 min.
BN-V20U (optional)approx. 2 hrs. 40 min.
BN-V400U (optional)approx. 5 hrs. 10 min.
Charging times are for a fully discharged battery pack.
6
GR-AX890_06-08_EN61/12/03, 10:50 AM |