USING REMOTE CONTROL UNIT (cont.)
48 EN
Insert Editing
You can record a new scene into a previously recorded
COUNTER R/M
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
PLAY/PAUSEoriginal audio remains unchanged.
NOTE:
REWFFUse the RM-V705U or RM-V700U remote control unit to
perform this procedure.
STOPSELECT MODE
Set the Power Switch to OPLAY�.
1
FIND EDIT-OUT POINT
Play back the tape, locate the point and press
2PAUSE on the camcorder or the remote control.
RESET COUNTER
Press and hold COUNTER R/M for more than
Power Switch31 second to reset the tape counter, then press again
for less than 1 second and make sure OM� appears.
Insert editingFIND EDIT-IN POINT
indicatorPress REW to go a little beyond the beginning of the
4scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the point
where the new scene should start.
M�0:12:34Tape Counter
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing
Viewfinder
5INSERT, press and release PAUSE. The Insert mode
is engaged. When the scene the camcorder is aimed
at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches
6O0:00:00�, editing stops automatically and the
camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP.
7
START/STOPNOTES:
cAfter step 5, Retake (Z pg. 19) can be performed.
REW
cThe tape may stop slightly before or after the desig-
nated end point, and noise bars may appear. Neither
PLAY
indicates a defect in the unit.
PAUSE
cOnly video signal is recorded in the Insert Editing
REW
mode.
INSERT
RM-V700URM-V705U
OR
(optional)(provided) |
ACEC
