USING REMOTE CONTROL UNIT (cont.)
38 EN
Insert Editing
COUNTER R/M
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V704U or RM-V700U remote control unit to
perform this procedure.
SELECT MODE
Set the Power switch to OPLAY�.
1
FIND EDIT-OUT POINT
Play back the tape, locate the Edit-Out point and
2press PAUSE on the camcorder or the remote
control.
RESET COUNTER
POWERPress and hold COUNTER R/M for more than
32 seconds to reset the tape counter, then press for
less than 1 second and make sure OM� appears in
M-1:23:45Tape Counterthe LCD monitor or the viewfinder.
Insert Editing IndicatorFIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the
4scene you want to replace, press PLAY to view the
LCD monitor orrecorded tape, and press PAUSE at exactly at the
viewfinderEdit-in point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing
5INSERT, press and release PAUSE. The Insert
mode is engaged, and the scene the camcorder is
aimed at appears on the screen.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches
6O0:00:00�, editing stops automatically and the
camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP.
START/STOP
7
REW
PAUSE
NOTES:
INSERT
cWhen Insert Editing is performed with the LCD monitor
PLAYfully opened, the original audio will be heard from the
speaker.
RM-V704U orcAfter step 5, Retake (Z pg. 14) can be performed.
RM-V700U (provided)cThe tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
cOnly video signal is recorded in the Insert Editing
mode. |