USER MAINTENANCE
50 EN
LENS COVER Open/Close RingAfter Use
Set the Power Switch to OPOWER OFF� to turn off
1the camcorder.
Open the LCD monitor to an angle of over 60
2degrees. Slide EJECT to open the cassette holder, then
remove the cassette.
Close and lock the cassette holder by pressing PUSH.
3
Close and lock the LCD monitor.
BATTERY RELEASE
4
Set to OPOWER OFF�.
Slide BATTERY RELEASE to remove the battery pack.
5
Turn the LENS COVER Open/Close Ring to close
6
the lens cover.
Cleaning The Camcorder
CLEAN EXTERIOR
1Wipe gently with a soft cloth.
Remove.
YPut cloth in diluted mild soap and wring it well to
PUSH ButtonEJECT Switchwipe off heavy dirt, then wipe again with a dry
cloth.
CLEAN LCD MONITOR
2Open the LCD monitor and wipe it gently with a soft
cloth. Be careful not to damage the monitor. Close
the LCD monitor.
CLEAN LENS
3Blow it with a blower brush, then wipe it gently with
lens cleaning paper.
REMOVE EYEPIECE
4Turn the eyepiece counterclockwise and pull it out.
CLEAN VIEWFINDER
5Remove dust using a blower brush.
RE-ATTACH EYEPIECE
6Re-attach the eyepiece and turn it clockwise.
NOTES:
cAvoid using strong cleaning agents such as benzine or alcohol.
cCleaning should be done only after the battery pack has been removed or other power units have been
disconnected.
cMold may form if the lens is left dirty.
cWhen using a cleaner or chemically treated cloth, refer to the cautions that came with it.
cWhen removing the eyepiece, be sure to hold the viewfinder securely. |
ACEC
