22 ENDIGITAL STILL CAMERA (D.S.C.) SHOOTING
SNAPSHOT ButtonLENS COVERBasic Shooting
Open/Close Ring
When shooting a still image, it is not recorded onto the
tape, but it is stored in the camcorder's built-in memory in
the selected Picture Mode. A stored still image data can be
Systemtransferred to a PC, saved, and processed using a Paint
SelectSoftware program (Z pg. 53).
SwitchA still image processed on the PC can be also inserted
onto a tape (Z pg. 63).
MODE SELECTION
SELECT OPERATION SYSTEM AND
1MODE
MENU ButtonTurn the LENS COVER Open/Close Ring to open the
Power lamplens cover, then set the System Select Switch to
OD.S.C.�. Set the Power Switch to OPRO.�.
Y The power lamp lights and an image appears.
SELECT PICTURE MODE
2Do steps 2 and 3 of OOPERATION� on pg. 24.
Set OPICTURE� to OFINE� or OSTANDARD� in the
Select DialPower SwitchMenu Screen as required.
DisplayYThere are two modes: FINE allows you to shoot up
to approx. 30 still images with higher resolution,
4NEXTMenu Screenand STANDARD allows you to shoot up to approx.
M . W . B .AUTO
D . ZOOMON60 still images with lower resolution.
TELE MACROOFF
DATE TIME
TAPE LENGTHT30SELECT SNAPSHOT MODE
PICTUREFINE3
SNAPSHOTFULLRotate the Select Dial to move the highlight bar to
OSNAPSHOT�, and press it. The SNAPSHOT Menu
4RETURN
appears.
Rotate the Select Dial to move the highlight bar to the
SNAPSHOTappropriate mode among the 5 Snapshot modes
SNAPSHOT Menu
FULL(Z pg. 23), and press it. Selection is complete.
PIN UP
MULTI 4
MULTI 9CLOSE MENU SCREEN
M . DRIVE4
The Menu Screen reappears with the highlight bar on
ORETURN�. Press the Select Dial again to close the
EXITMenu Screen.
STILL IMAGE STORAGE
4NEXTMenu Screen
M . W . B .AUTOTAKE SNAPSHOT
D . ZOOMON
TELE MACROOFF1Press SNAPSHOT.
DATE TIME
TAPE LENGTHT30
PICTUREFINEYRegardless of the Power Switch position (OAUTO�
SNAPSHOTPIN-UPor OPRO.�), Snapshot recording takes place using
4RETURNthe selected Snapshot mode.
YA still image is stored in the built-in memory and
displayed for approx. 2 seconds. While the stillNormal Screen
image remains displayed, that image is in the
During Snapshot mode
process of being stored in memory, and it is
PNo display
therefore impossible to take another shot during that
(Pin-Up)(Full)
time. When the still image disappears and the scene
Pyou are currently aimed at appears on the screen,
MD (M.DRIVE)M4 (MULTI-4)you may take another shot.
YThe remaining number of shots available is
M9 (MULTI-9)displayed. |
ACEC
