Master Page: Right
GR-D200US.book Page 21 Friday, April 11, 2003 1:05 PM
Shuttle SearchNOTES:
I Before starting Blank Search, if the current position
Allows high-speed search in either direction during is at a blank portion, the camcorder searches in
video playback.the reverse direction. If the current position is at a
1) During playback, press FF (5) for forward recorded portion, the camcorder searches in the
search, or REW (3) for reverse search.forward direction.
2) To resume normal playback, press PLAY (4/9).I Blank Search does not work if ?HEAD CLEANING
I During playback, press and hold FF (5) or REQUIRED. USE CLEANING CASSETTE? has
REW (3). The search continues as long as appeared with the tape.
you hold the button. Once you release the I If the beginning or end of the tape is reached
button, normal playback resumes.during Blank Search, the camcorder stops
I A slight mosaic effect appears on the display automatically.
during Shuttle Search. This is not a I A blank portion which is shorter than 5 seconds of
malfunction.tape may not be detected.
I The detected blank portion may be located
ATTENTION:
between recorded scenes. Before you start
During Shuttle Search, parts of
recording, make sure there is no recorded scene
the picture may not be clearly
after the blank portion.
visible, particularly on the left
side of the screen.
Slow-Motion Playback
Blank SearchFrame-By-Frame Playback
Helps you find where you should start recording in Playback Zoom
the middle of a tape to avoid time code interruption.
Playback Special Effects
( pg. 19)
Available only with the remote control (provided).
1Load a cassette. (pg.15)
( pg. 58)
2Set the VIDEO/MEMORY Switch to ?VIDEO?.
3Set the Power Switch to ?PLAY? while pressing
down the Lock Button located on the switch.
4Press MENU. The Menu Screen appears.
5Press + or - to select ?tVIDEO? and press
SELECT/SET.
6Press + or - to select ?BLANK SRCH? and press
SELECT/SET. The Sub Menu appears.
7Press + or - to select
?EXECUTE? and press
SELECT/SET.
BLANK SEARCHVIDEO RECORDING & PLAYBACK
I The ?BLANK PUSH "STOP" BUTON
SEARCH? TO CANCEL
indication appears
and the camcorder
automatically starts
reverse or forward search, then stops at the
spot which is about 3 seconds of tape before
the beginning of the detected blank portion.
I To cancel Blank Search midway, press STOP
(8). |
ACEC
