HOW TO ATTACH THE CORE FILTER
Attach the Core Filter(s) (if provided with your model pg. 5) to an optional cable(s). The Core Filter reduces
interference.
123 cm3
StopperWind once
Release theRun the cable through the Core Filter, leaving approx. 3 cmClose the Core Filter until it
stoppers on bothof cable between the cable plug and the Core Filter. Windclicks shut.
ends of the Corethe cable once around the outside of the Core Filter as
Filter.shown in the illustration.
Y Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
When connecting cables, attach the end with the Core Filter to the camcorder.
Be sure to use a cable with a thickness that will allow it to be wound around the core filter.
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when
ODEMO MODE� is set to OON� (factory-preset).$
Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch y is set to O � or O �
and no cassette is in the camcorder.
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
ODEMO MODE� remains OON� even if the camcorder power ist
turned off.
To cancel Automatic Demonstration:
1. Set the Power Switch y to O � while pressing down the Locky
Button t located on the switch and press the MENU/VOLUME
wheel $ in. The Menu Screen appears.
Sub Menu
2. Rotate the MENU/VOLUME wheel $ to select O (SYSTEM)�
and press it.STYS EM
3. Rotate the MENU/VOLUME wheel $ to select ODEMO MODE�
and press it. The Sub Menu appears.
DEMO MODE � OFF
4. Rotate the MENU/VOLUME wheel $ to select OOFF� and pressON
it.
5. Rotate the MENU/VOLUME wheel $ to select ORETURN�,
and press it twice. The normal screen appears.RETURN
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
EN
6None
01 D50/40/30/20EK 01-10602.12.13, 9:21 |
ACEC
