SNAP MODETELE MACRO
Refer to OSnapshot� ( pg. 18).[OFF]: To turn off this function.
GAIN UPON: Usually the distance to a subject where the lens
is in focus depends on the zoom magnification.
OFF: Allows you to shoot dark scenes with no picture
Unless there is a distance more than 1m to the
brightness adjustment.
subject, the lens is out of focus at the maximum
[AGC]: The overall appearance may be grainy, but thetelephoto setting. When set to OON�, you can shoot a
image is bright.subject as large as possible at a distance of approx.
AUTO : The shutter speed is automatically60 cm.
adjusted (1/25 N 1/200 sec.). Shooting a subject inY Depending on the zoom position, the lens may go
low or poor lighting at 1/25 sec. shutter speedout of focus.
provides a brighter image than in the AGC mode, but
WIDE MODE
the subjectOs movements are not smooth or natural.
The overall appearance may be grainy. While the[OFF]: Records with no change in the screen ratio.
shutter speed is being automatically adjusted, O�For playback on a TV with a normal screen ratio.
is displayed.
CINEMA: Inserts black bands at the top and
bottom of the screen. During playback on
MANUAL
wide-screen TVs, the black bands at the top and
The O MANUAL� settings are effective only when thebottom of the screen are cut and the screen ratio
Power Switch y is set to O �.becomes 16:9. @ appears. When using this
mode, refer to your wide-screen TVOs instruction
MUAN ALmanual. During playback/recording on 4:3 TVs/LCD
DIS� ON
TELE MACRO� OFFmonitor/viewfinder, black bands are inserted at the
WIDE MODE � OFFtop and bottom of the screen and the image appears
WIND CUT � OFFlike a letterboxed 16:9 movie.
SQUEEZE : For playback on TVs with an aspect
ratio of 16:9. Naturally expands the image to fit the
screen without distortion. @ appears. When
RETURNusing this mode, refer to your wide-screen TVOs
instruction manual. During playback/recording on 4:3
DISTVs/LCD monitor/viewfinder, the image is elongated
vertically.
OFF: To turn off this function.
[ON ]: To compensate for unstable images causedWIND CUT
by camera-shake, particularly at high magnification.[OFF]: Disengages the function which cuts down on
noise created by wind.
NOTES:
ON : Helps cut down on noise created by wind.
I Accurate stabilisation may not be possible if hand shake
O� * appears. The quality of the sound will
is excessive, or under the following conditions:
change. This is normal.
Y When shooting subjects with vertical or horizontal
stripes.
Y When shooting dark or dim subjects.
[ ] = Factory-preset
Y When shooting subjects with excessive backlighting.
Y When shooting scenes with movement in various
directions.
Y When shooting scenes with low-contrast backgrounds.
I Switch off this mode when recording with the camcorder
on a tripod.
I The O� indicator 8 blinks or goes out if the Stabiliser
cannot be used.
EN
22USING MENUS FOR DETAILED ADJUSTMENT
1 D50/30A EN 16-272203.2.4, 17:56 |
ACEC
