MasterPage: Start_Right
G R-D340PAL.book Pag e 17 Thursday , October 27 , 2005 3:19 PM
GETTING STARTEDEN17
I Once the cassette holder is closed, it recedes
Loading/Unloading A Cassetteautomatically. Wait until it recedes completely
before closing the cassette holder cover.
The camcorder needs to be powered up to load
I When the battery pack?s charge is low, you may
or eject a cassette.
not be able to close the cassette holder cover. Do
Cassetteholder not apply force. Replace the battery pack with a
PUSHcoverfully charged one or use AC power before
OPEN/EJECTcontinuing.
3Close the cassette holder cover firmly until it
locks into place.
To protectvaluablerecordings
Slide the erase protection tab on the back of the
tape in the direction of ?SAVE?. This prevents the
tape from being recorded over. To record on this
tape, slide the tab back to ?REC? before loading
it.
CassetteholderErase
protectiontabNOTES:
Makesure thewindowsideI If you wait a few seconds and the cassette holder
isfacingout.does not open, close the cassette holder cover GETTING STARTED
and try again. If the cassette holder still does not
1Slide and hold OPEN/EJECT in the direction open, turn the camcorder off then on again.
of the arrow, then pull the cassette holder cover I If the tape does not load properly, open the
open until it locks. The cassette holder opens cassette holder cover fully and remove the
automatically.cassette. A few minutes later, insert it again.
I Do not touch internal components.I When the camcorder is suddenly moved from a
cold place to a warm environment, wait a short
2Insert or remove a tape and press ?PUSH? to
time before opening the cassette holder cover.
close the cassette holder.
I Be sure to press only the section labelled ?PUSH?
to close the cassette holder; touching other parts
may cause your finger to get caught in the
cassette holder, resulting in injury or product
damage. |
ACEC
