MasterPage: Left
GR-D350UC.book Page 12 Wednesday, October 19, 2005 1:51 PM
GETTING STARTED12 EN
To detach the battery packUsing The Battery Pack
Slide the battery pack upward while pressing
Perform steps 2 � 3 in OCharging The Battery
PUSH BATT. to detach it.
Pack�.
Battery packCharging time
Maximum continuous recording time
BN-VF707U*Approx. 1 hr. 30 min.
LCD monitor
BN-VF714UApprox. 2 hrs. 40 min.Battery packViewŢnder on
on
BN-VF733UApprox. 5 hrs. 40 min.
BN-VF707U*1 hr. 30 min.1 hr. 40 min.
* Provided
BN-VF714U3 hrs.3 hrs.25 min.
NOTES:BN-VF733U7 hrs.8 hrs.
÷÷÷÷ This product includes patented and other
* Provided
proprietary technology and will operate only
with JVC Data Battery. Use the JVC BN-NOTES:
VF707U/VF714U/VF733U battery packs. Using ÷ Recording time is reduced signiŢcantly under the
generic non-JVC batteries can cause damage following conditions:
to the internal charging circuitry.IZoom or Record-Standby mode is engaged
I If the protective cap is attached to the battery repeatedly.
pack, remove it Ţrst.
IThe LCD monitor is used repeatedly.
I During charging, the camcorder cannot be IThe playback mode is engaged repeatedly.
operated.I Before extended use, it is recommended that you
I Charging is not possible if the wrong type of prepare enough battery packs to cover 3 times the
battery is used.planned shooting time.
I When charging the battery pack for the Ţrst time
or after a long storage period, the POWER/ATTENTION:
CHARGE lamp may not light. In this case, remove Before detaching the power source, make sure that
the battery pack from the camcorder, then try the camcorderOs power is turned off. Failure to do so
charging again.can result in a camcorder malfunction.
I If the battery operation time remains extremely
Data Battery System
short even after having been fully charged, the
battery is worn out and needs to be replaced. You can check the remaining battery power and
Please purchase a new one.the recordable time.
I Since the AC Adapter processes electricity 1) Make sure the battery is attached and the
internally, it becomes warm during use. Be sure to Power Switch is set to OOFF�.
use it only in well-ventilated areas.2) Open the LCD monitor fully.
I Using the optional AA-VF7 Battery Charger, you
3) Press DATA, and the battery status screen
can charge the BN-VF707U/VF714U/VF733U
appears.
battery pack without the camcorder.
I It is displayed for approx. 5 seconds if the
I After 5 minutes has elapsed in Record-Standby
button is pressed and released quickly, and for
mode with the cassette inserted and no operation
approx. 15 seconds if the button is pressed
is performed (O PAUSE� indicator may not
and hold for several seconds.
appear), the camcorder will automatically turn off
its power supplied from the AC adapter. In this I If OCOMMUNICATION ERROR� appears
case, the battery charge starts if the battery is instead of the battery status even though you
attached to the camcorder.tried to press DATA several times, there may
be a problem with your battery. In such a case,
consult your nearest JVC dealer.
CONTINUED ON NEXT PAGE |
ACEC
