MasterPage: Left
GR-D370AH_EN.book Page 46 Monday, April 17, 2006 2:24 PM
EDITING46 EN
Audio DubbingInsert Editing
The audio track can be customised only when You can record a new scene into a previously
recorded in the 12-BIT and SP modes. recorded tape, replacing a section of the original
( pg. 33)recording with minimal picture distortion at the in
IUse the provided remote control. and out points. The original audio remains
unchanged.
SpeakerIUse the provided remote control.
NOTES:
IBefore performing the following steps, make sure
that OTIME CODE� in both Recording and
Playback Menus is set to OON�. ( pg. 32, 35, 36)
START/IInsert Editing is not possible on a tape recorded in
STOP
the LP mode or on a blank portion of a tape.
PAUSE
REWPLAYStereo Microphone
INSERTSTOP1Play back the tape, locate the Edit-Out point
A.DUBand press PAUSE (8). ConŢrm the time code at
this point. ( pg. 22)
1Play back the tape to locate the point where 2Press REW (1) until the Edit-In point is
editing will start, then press PAUSE (8).located, then press PAUSE (8).
2While holding A. DUB () on the remote 3Press and hold INSERT () on the remote
control, press PAUSE (8). The O8 � indicator control, then press PAUSE (8). The O8 �
appears.indicator and the Time Code (min.:sec.) appear
3Press PLAY (3), then begin Onarrating�. and the camcorder enters Insert-Pause mode.
Speak into the microphone.4Press START/STOP to begin editing.
ITo pause dubbing, press PAUSE (8).IConŢrm the insert at the time code you checked in
4To end Audio Dubbing, press PAUSE (8), step 1.
then STOP (7).ITo pause editing, press START/STOP. Press it
again to resume editing.
To hear the dubbed sound during playback
5To end Insert Editing, press START/STOP,
Set ONARRATION� to OON� or OMIX�.
then STOP (7) on the remote control.
( pg. 32, 36)
NOTES:
NOTES:
IProgram AE, Effects and Shutter Effects
ISound is not heard from the speaker during Audio
( pg. 42) can be used to spice up the scenes
Dubbing.
being edited during Insert Editing.
IWhen editing onto a tape that was recorded at
IDuring Insert Editing, the date and time
12-BIT, the old and new soundtracks are recorded
information changes.
separately.
IIf you perform Insert Editing onto a blank space
IIf you dub onto a blank space on the tape, the
on the tape, the audio and video may be
sound may be disrupted. Make sure you only edit
disrupted. Make sure you only edit recorded
recorded areas.
areas.
IIf feedback or howling occurs during TV playback,
IDuring Insert Editing, when the tape moves to
move the camcorderOs microphone away from the
scenes recorded in the LP mode or a blank
TV, or turn down the TVOs volume.
portion, Insert Editing stops. ( pg. 50)
IIf you change from 12-BIT to 16-BIT in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-BIT recording began.
IDuring Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes
recorded in 16-BIT audio or a blank portion, Audio
Dubbing stops. |
ACEC
