MasterPage: Left
GR-D372US_EN.book Page 12 Friday, April 14, 2006 12:28 PM
GETTING STARTED12 EN
How To Attach The Shoulder Strap
Provided Accessories
Follow the illustration.
1Thread the strap through the eyelet.
2Fold it back and thread it through the strap
ORguide and the buckle.
I To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3Slide the strap guide fully towards the eyelet.
Strap guide
2
Buckle
2
1 AC Adapter AP-V14U or AP-V18U
2 Battery Pack BN-VF707U
3 Audio/Video Cable (ż3.5 mini-plug to RCA plug)
4 USB Cable
5 Core Filter (for USB cable, see the right
column for attachment)13
6 CD-ROM
Eyelet
7 Shoulder Strap (see the right column for
attachment)How To Attach The Core Filter
8 Lens Cap (see the bottom for attachment)
Attach the core Ţlters to the cables. The core
NOTES:Å¢lter reduces interference.
I In order to maintain optimum performance of the
1Release the stoppers on both ends of the
camcorder, provided cables may be equipped with
core Ţlter.
one or more core Ţlter. If a cable has only one core
Ţlter, the end that is closest to the Ţlter should be
connected to the camcorder.
I Make sure to use the provided cables for
connections. Do not use any other cables.
Stopper
How To Attach The Lens Cap2Run the cable through the core Ţlter, leaving
approx. 3 cm (1-3/16") of cable between the
To protect the lens, attach
cable plug and the core Ţlter.
the provided lens cap to the Wind the cable once around the outside of the
camcorder as shown in the core Ţlter as shown in the illustration.
illustration. Core Ţlter
3 cm (1/3-1/16")
NOTE:
To conŢrm the lens cap is on
correctly make sure the cap is
�ush to the camcorder.
Wind once.
3Close the core Ţlter until it clicks shut.
NOTES:
Place here during
I Take care not to damage the cable.
shooting.
I When connecting a cable, attach the end with the
core Ţlter to the camcorder. |
ACEC
