Dubbing To Or From A Video Unit5. Press the Recording Start/Stop button e to start
recording. 3 rotates.
Equipped With A DV Connector
(Digital Dubbing)6. Press the Recording Start/Stop button e again to
engage the Record-Pause mode. 3 stops
It is also possible to copy recorded scenes from thisrotating.
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little ifNOTES:
any image or sound deterioration.I Digital Dubbing is performed in the sound mode recorded
on the original tape, regardless of the current OSOUND
MODE� setting ( pg. 28).
To Use This Camcorder As A PlayerI During Digital Dubbing, incoming signals cannot be
output through the video or audio connectors if they are
1Make sure all units are turned off. Connect thiscopy-guarded.
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the illustration.
2Set this camcorderOs VIDEO/MEMORY Switch 4 to
47e
OVIDEO�, then the Power Switch u to OPLAY� while
pressing down the Lock Button y located on the
switch, turn on the video unitOs power, and insert the
appropriate cassettes in this camcorder and the video
unit.
3Press 4 7 to play back the source tape.
4While watching the playback on the monitor, engage
the DV connector-equipped video unitOs record mode
from the spot on the source tape you want to begin
To DV @
recording.
NOTES:
y
I It is recommended to use the AC Adapter as theCore filterOFF(CHARGE)
PLAY
power supply instead of the battery pack ( pg. 7).
I If the remote control is used when both the player and
DV cable
recorder are JVC video units, both units will perform the(optional)
same operation. To prevent this from happening, pressu
the buttons on both units.
I If a blank portion or disturbed image is played back onCore filter
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
To DV
I Even though the DV cable is connected correctly,
IN/OUT
sometimes the image may not appear in step 4. If thisVideo unit equipped
occurs, turn off the power and make connections again.with DV connector
I If OPlayback Zoom� ( pg. 14, 35), OPlayback Special
Effects� ( pg. 35) or OSnapshot� is attempted during
playback, only the original playback image recorded on
the tape is output from the DV connector @.
I When using a DV cable, be sure to use the optional
JVC VC-VDV204U DV cable.
To Use This Camcorder As A Recorder
1. Set this camcorderOs VIDEO/MEMORY Switch 4 to
OVIDEO�, then the Power Switch u to OPLAY� while
pressing down the Lock Button y located on the
switch.
2. Set OREC MODE� to OSP� or OLP� in the Menu Screen
( pg. 31).
3. Connect the DV cable as shown in the illustration
and load a cassette to record on.
4. Press the Recording Start/Stop button e to engage
the Record-Pause mode. ODV. IN � appears on the
screen.
EN
34DUBBING
1 GR-D90/70A EN 23-343403.2.4, 17:07 |
ACEC
