MasterPage: Left
GR-D94US.book Page 42 Monday, November 17, 2003 2:12 PM
TROUBLESHOOTING42 EN
Images on the LCD monitor appear dark or whitish.An error indication (E01, E02 or E06) appears.
I In places subject to low temperature, images become dark I A malfunction of some kind has occured. In this case the
due to the characteristics of the LCD monitor. When this camcorder?s functions become unusable.
happens, the displayed colors differ from those that are H pg. 44.
actually recorded. This is not a defect of the camcorder.
HAdjust the brightness and angle of the LCD monitor. An error indication (E03 or E04) appears.
( pg. 9, 12)
I A malfunction of some kind has occured. In this case the
I When the LCD monitor?s fluorescent light reaches the end
camcorder?s functions become unusable.
of its service life, images on the LCD monitor become dark.
H pg. 44.
HConsult your nearest JVC dealer.
The remote control does not work.
Colored bright spots appear all over the LCD
monitor or the viewfinder.I ?REMOTE? is set to ?OFF?.
HSet ?REMOTE? to ?ON?. ( pg. 25, 27)
I The LCD monitor and the viewfinder are made with high-
I The remote control does not point at the remote sensor.
precision technology. However, black spots or bright spots
HPoint at the remote sensor. ( pg. 15)
of light (red, green or blue) may appear constantly on the
I The remote control batteries are exhausted.
LCD monitor or the viewfinder during recording or
HReplace the batteries with fresh ones. ( pg. 15)
playback. These spots are not recorded on the tape. This is
not due to any defect of the unit. (Effective dots: more than
99.99 %)
The indicators and the image color on the LCD
monitor are not clear.
I This may occur when the surface or the edge of the LCD
monitor is pressed.
The cassette will not load properly.
I The battery?s charge is low.
HInstall a fully charged battery. ( pg. 6, 7)
The memory card cannot be removed from the
camcorder.
HPush in the memory card a few more times. ( pg. 10)
Picture does not appear on the LCD monitor.
I The viewfinder is pulled out and ?PRIORITY? is set to
?FINDER?.
HPush the viewfinder back in or set ?PRIORITY? to ?LCD?.
( pg. 12, 25, 27)
I The LCD monitor?s brightness setting is too dark.
HAdjust the brightness of the LCD monitor. ( pg. 9)
HIf the monitor is tilted upward 180 degrees, open the
monitor fully. ( pg. 12)
Images on the LCD monitor are jittery.
I The speaker volume is too great.
HTurn the speaker volume down. ( pg. 14)
The LCD monitor, the viewfinder and the lens have
become dirty (ex. fingerprints).
HWipe them gently with soft cloth. Wiping strongly can
cause damage. ( pg. 48) To clean the viewfinder, please
consult your nearest JVC dealer.
Time code does not appear.
I ?TIME CODE? is set to ?OFF?.
HSet ?TIME CODE? to ?ON?. ( pg. 25, 27, 28) |
ACEC
