Master Page: Right
GR-DV4000PAL.book Page 63 Friday, February 14, 2003 10:30 PM
EN 63
Picture Wipe And Dissolve Menu Automatic Editing To VCR
(available only for Random Assemble Editing)
You can use not only the wipe/fader effects on
page 32 but also the picture wipe and dissolve
effects below.
DISSOLVE: The new scene gradually appears
as the old one gradually disappears.PAUSE
WIPE - CORNER: The new scene wipes in
over the previous one from the upper right corner to
the lower left corner.
WIPE - WINDOW: The next scene gradually VCR REC STBY
wipes in from the centre of the screen toward the 13Rewind the tape in the camcorder to the
corners, covering the previous scene.
WIPE - SLIDE: The next scene gradually wipes beginning of the scene you want to edit and press
in over the previous one from right to left.PAUSE (9).
14Press VCR REC STBY (79), or manually
WIPE - DOOR: The previous scene wipes out engage the VCR?s Record-Pause mode.
from the centre to the right and left, like a door
being pushed open to reveal the next scene.15Press the Recording Start/Stop Button on the
WIPE - SCROLL: The new scene wipes in over camcorder. Editing proceeds as programmed,
right through to the end of the last registered
the last one from the bottom of the screen to the top.scene.
WIPE - SHUTTER: The new scene wipes in I When dubbing is complete, the camcorder
over the previous one from the centre toward the top
and bottom of the screen.enters the Pause mode, and the VCR enters its
Record-Pause mode.
I If you do not register an Edit-Out point, the
tape will be dubbed all the way to the end
automatically.
I If you operate the camcorder during automatic
editing, the VCR will enter its Record-Pause
mode and automatic editing will stop.
16Engage the Stop modes for the camcorder and
the VCR.
To make the R.A.Edit counter display disappear,
press R.A.EDIT ON/OFF on the remote control.ADVANCED FEATURES
NOTES:
I Pressing R.A.EDIT ON/OFF on the remote control
clears all settings registered during Random
Assemble Editing.
I When the editing cable is connected to the remote
control?s PAUSE IN connector during dubbing,
make sure the remote control is pointed at the
VCR?s sensor, and the path between the two is
unobstructed.
I Random Assemble Editing may not function
properly when using a tape including several
duplicated time codes. ( pg. 19)
CONTINUED ON NEXT PAGE |
ACEC
