GETTING STARTED (cont.)
8 EN
Grip Adjustment
Separate the Velcro strip.
Power1
Zoom Lever
Pass your right hand through the loop and grasp
2the grip.
Recording
Start/Stop buttonAdjust so that your thumb and fingers can easily
3operate the Recording Start/Stop Button and
Power Zoom Lever. Refasten the Velcro strip.
Power Switch
Viewfinder Adjustment
Dioptre AdjustmentSet the Power Switch to O � or O � while
Control
1pressing down the Lock Button located on the
switch.
Turn the Dioptre Adjustment Control until the
2indications in the viewfinder are clearly
focused.
PAUSEShoulder Strap Attachment
Make sure the battery pack or DC cord is
1removed. Following the illustration, thread the
strap through the eyelet 1, then fold it back and
thread it through the buckle 2. Repeat the
procedure to attach the other end of the strap to
21the other eyelet 3 located under the Grip Strap,
making sure the strap is not twisted.
3
Tripod Mounting
Align the screw and camera direction stud on
1the tripod with the cameraOs mounting socket
and stud hole. Then tighten the screw.
YSome tripods are not equipped with studs.
CAUTION:
When using a tripod, be sure to open and
extend its legs fully to stabilise the
camcorder. To prevent damage to the unit
caused by falling over, do not use a small-
sized tripod. |
ACEC
